Eskimo Z71T8 - Manuel (Page 10)

Check for parts online at www.geteskimo.com or call 800-345-6007 M-F 8-5 CST Check for parts online at www.geteskimo.com or call 800-345-6007 M-F 8-5 CST 10
Operator's Manual
51cc and 71cc Shark™ Power Ice Augers
SERvICE, TROUBlESHOOTING
AND REPAIR
SERvICE INFORmATION
At Ardisam, we build quality and durability into the design of
our products; but no amount of careful design by us, and careful
maintenance by you, can guarantee a repair-free life for your
auger. Most repairs will be minor, and easily fixed by following
the suggestions in the troubleshooting guide in this section.
The guide will help you pinpoint the causes of common problems
and identify remedies.
For more complicated repairs, you may want to rely on your
retailer or an authorized repair center (contact your retailer for
a list of authorized mechanics in your area). A parts breakdown
is included in this manual and can also be found on our website,
www.geteskimo.com.
We will always be glad to answer any questions you have, or
help you find suitable assistance. To order parts or inquire about
warranty, call or write us at the address found below, under the
section ordering repair parts.
ICE POINT REPlACEmENT (SEE FIGURE 1)
1. Remove blade protector and both blades.
2. Remove nut and retaining bolt from point.
3. Using a locking pliers, grasp point and pull out. If holder
doesn’t come out with the point, remove with pliers.
4. With locking pliers, push in new point and holder aligning
bolt hole in point with holes in auger shaft. DO NOT damage
end of point.
NOTE: when installing holder in auger shaft, edges of holder
may shave off.
5. Insert retaining bolt and tighten with nut.
6. Re-attach both blades and put blade protector back on.
CAUTION
AvOID INjURY! AUGER BlADES AND POINT ARE
ExTREmElY SHARP. USE CAUTION WHEN REmOvING
& REPlACING.
PRACTICE SAFETY AT All TImES. ENGINE mUST BE
TURNED OFF AND AllOWED TO COOl, AND SPARk
PlUG WIRE mUST BE DISCONNECTED BEFORE
ATTEmPTING ANY mAINTENANCE OR REPAIR.
Figure 1
auger shaft
nut
point
holder
bolt
bolt hole
ORDERING REPAIR PARTS
Parts may be obtained from the store where your auger was
purchased or direct from the factory. To order from the factory,
call, e-mail, or order online at www.geteskimo.com:
Eskimo® Ice Fishing Gear,
A Division of Ardisam, Inc.
1-800-345-6007
E-mail: [email protected]
Please include the following information with your order:
1. Part numbers
2. Part description
3. Quantity
4. Model number and serial number