Danby DAC 5209M - Manuel (Page 8)

7
OPERATING INSTRUCTIONS
SELECTOR SWITCH
The selector switch controls fan speed and/or cooling speed. To
set desired cooling temperature, simply rotate the SELECTOR
knob to the appropriate setting.
FAN SPEEDS
• LOW FAN will circulate air at minimum speed
without cooling.
• HIGH FAN will circulate air at maximum speed
without cooling.
COOLING MODES
• LOW COOL provides cooling with minimum air
circulation. Recommended for night-time use.
• HIGH COOL provides cooling with maximum
air circulation. Recommended for quick cooling or for
extremely hot days. Once room is cooled, reduce
setting to LOW COOL.
• OFF shuts-down the unit completely
NOTE: Always allow 3 minutes before switching
from one mode to another.
Thermostat
Selector
Switch
THERMOSTAT
The thermostat automatically controls the (compressor) cooling cycle and maintains the
selected room temperature. To set the thermostat, rotate the thermostat knob to the desired
cooling setting (1 warmest - 7 coldest). The fan motor will continue to operate after the
compressor (cooling) has cycled off. This is normal.
When using FAN control, turn selector switch slowly, allowing unit to adjust. When using
THERMOSTAT, be sure to allow three minutes before changing temperature. Adjusting too
quickly may cause compressor to overload.