Danby DAC 5209M - Manuel (Page 7)

6
INSTALLATION (cont’d)
1) Assembly of the Upper Channel to Cabinet.
• “L” Shaped Top Channel: Install the “L” shaped
channel to the top of the cabinet as shown in Fig. 3,
using four (4) 3/8” screws.
2) Assembly of the Side Curtains to Cabinet.
• Extend the shutter from the shutter frame and
slide it into the shutter tabs on the side channel of
the air conditioner, as shown in Fig. 4.
• Slide the shutters into the top (“L” Shaped) and
bottom (“U” Shaped) channels. The shutters are
identified (on frame) as left and right.
3) Completing the Installation
• Cut the foam (non adhesive) sealing strip to fit the
area of the window sill that the air conditioner will
rest on.
• Carefully place the air conditioner into the window
with the “L” shaped mounting bracket (on top)
positioned in front of the upper window sash. The
bottom of the cabinet should be positioned on the
“recessed” portion of the window frame. Pull the
window down until it rests just behind the front
flange of the (top) “L” shaped mounting bracket
(See Fig. 5).
• Expand the shutter frames (fully) on each side and
secure the top of the frames to the window sash
using one 3/4” screw on each side and one in the
“L” shaped mounting bracket (Fig. 5).
• Secure the shutter clamp on each side of the
(lower) shutter and secure to window sill using one
3/4” screw on each side (Fig. 5).
• Place the second foam sealing strip to fit the
opening between the inside and outside windows,
then attach the safety lock to the outside window
frame using one 3/4” screw (See Fig. 6).
3/8” screws
“L” shaped
mounting bracket
“U” shaped Channel
(Factory Installed)
Fig. 3
Slide down into t
abs
Shutter tabs
Shutter
Shutter frame Fig. 4
Window sash
“L” Shaped
Mounting
Bracket
Shutter clamps
3/4” screws
Fig. 5
Safety Lock
3/4” screw
Foam Seal
Fig. 6
PLEASE NOTE: Window applications come in a
variety of different styles. Therefore, it may be
necessary to modify or improvise your particular
installation.