Danby DAC 5209M - Manuel (Page 5)

The power cord supplied with this air conditioner contains a device that senses
damage to the power cord. To test if your power cord is working properly, you
must do the following:
Your Danby appliance is designed to be highly efficient in energy
savings. Follow these recommendations for greater efficiency.
1) Select a thermostat setting that suits your
comfort needs and leave at that chosen
setting.
2) The filter is very efficient in removing
airborne particles. Keep the air filter clean.
Normally, filters should be cleaned every 2
weeks. More frequent cleaning my be
necessary depending on indoor air quality.
3) Use drapes, curtains or shades to keep
direct sunlight from penetrating and heating
room, but do not allow drapes or curtains to
obstruct the air flow around the unit.
4) Start your air conditioner before the
outdoor air becomes hot and uncomfortable, to
avoid an initial period of discomfort while the
unit is cooling off the room.
5) When outdoor temperatures are cool
enough, use HIGH or LOW FAN only. This
circulates indoor air, providing some cooling
comfort, and utilizes less electricity than when
operating on a cooling setting.
NOTE: The power cord supplied with this air
conditioner contains a current leakage
detection device designed to reduce the risk
of fire. In the event the power supply cord is
damaged, it cannot be repaired and must be
replaced with a new cord from the product
manufacturer.
• Under no circumstances should this device
be used to turn the unit on or off.
• The “RESET” button must always be pushed
in (engaged) for correct operation.
• The power supply cord must be replaced if it
fails to reset when the “TEST” button is
pushed in.
1) Connect the power supply cord to an
electrical outlet.
2) The power supply cord has two buttons
located on the head of the plug. One button is
marked “TEST”, and the other is marked
“RESET”. Press the “TEST” button; you will
hear a click as the “RESET” button pops out.
3) Press the “RESET” button; you will hear a
click as the button engages.
4) The power supply cord is now energized
and supplying electricity to the air conditioner
(on some products this is also indicated by a
light on the plug head).
4
IMPORTANT SAFETY INFORMATION
POWER
SUPPLY CORD
ENERGY-
SAVING TIPS