Whirlpool Dishwasher Manuel d'utilisation

Page 9

Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".

Advertising
background image

10. Connect water pipe or tubing directly to water inlet

valve. Do Not run pipe or tubing across front of motor
or dishwasher legs. Turn on water supply and check

for leaks.

11. Check electrical requirements. Be sure to have correct

electrical supply and recommended grounding method.
See pages 4 and 5 for proper connections.

Top mounting brackets

attached to underside

of countertop

Philiips head
screws
No. 10

X Vz"

Do not drop
screws into tub.

12. Open dishwasher door and remove all shipping materi­

als. Remove bottom rack. Place a newspaper or large
sheet of paper over bottom of dishwasher to protect the
pump area when securing dishwasher to countertop.

13. Secure dishwasher to countertop with two (2) No.

10 X Vs" Phillips-head screws from parts bag. You

MUST secure dishwasher to keep it from tilting when
door is opened or closed. Do Not drop screws in

dishwasher tub. if screws should fall into the pump,
pump and motor failure may occur. Remove paper
from bottom of dishwasher.

14. Open door approximately 3" (7.6 cm) and check for

equal spacing between inner door and tub sides.

If necessary, loosen screws that fasten dishwasher

to countertop and shift tub. Tighten screws.

Equally spaced

15. Check door for proper operation. Door should close

easily without slamming and open with its own weight.
If necessary, close door and adjust both door springs
by moving spring ends to different holes in base.

16. Take a few minutes to read the Use and Care Guide

to fully understand your new dishwasher.

17. Check that all parts have been installed and no steps

were skipped. Check that you have all the tools you
started with.

18. Reconnect power or plug in dishwasher.

19. Start dishwasher and allow it to complete a cycle.

Check that dishwasher is working properly and that
there are no water leaks.

20. Replace access panel and toe panel. The toe panel

must be positioned to contact floor.

21. If changing color of door and access panel or installing

custom panels, follow the “To change door and access
panel color” instructions, pages 9, 10 and 11.

Congratulations!

You have Just finished instaiiing your new

dishwasher. Keep instaliation instructions

available for easy reference.

(continued)

3369671-C

Advertising