Whirlpool Dishwasher - Manuel (Page 3)

AWARNING
Electrical Shock Hazard
Enclose dishwasher completely on the top,
sides, and rear.
Failure to do so can result in death or
electrical shock.
Read and follow the “Electrical requirements,” “Water
requirements,” and “Drain requirements” sections before
installing dishwasher.
Tools and materials needed for
installation:
• electric drill
• Phillips screwdriver
• 2 adjustable wrenches
•flat-blade screwdriver
• measuring tape
• pliers
• wire stripper and utility knife
• yis" and '/4" nut driver or hex
socket
• pipe wrench
• key hole saw
• tubing cutter (not shown)
• pipe-joint compound
• 3 twist-on wire connectors
for 16-gauge wire
• 90° elbow with ys" N.P.T.
external threads on one
end. The size of the other
end must fit your water
supply line.
Parts supplied for installation:
• 2 drain hose clamps
• drain hose
' 2 No. 10 X V2" Phillips-head
screws
Electrical requirements
AWARNING
'ii
Electrical Shock Hazard
Electrically ground dishwasher.
Connect ground wire to green ground connector
in terminal box.
Do not use an extension cord.
Failure to do so can result in death, fire,
or electrical shock.
A 120-volt, 60 Hz, AC only, 15- or 20-ampere, fused,
electrical supply is required. Time-delay fuse or circuit
breaker is recommended. It is recommended that a
separate circuit serving only this appliance be provided.
The dishwasher must be connected with copper wire only.
Wiring methods
Pick one method to follow depending upon your dishwasher
and local codes.
A. Direct wire method (cable con­
necting dishwasher to a junction box)
Recommended grounding method
1. Disconnect power.
2. Run flexible, armored or nonmetallic sheathed, copper
cable (with grounding wire) from the fused disconnect,
circuit breaker or junction box through the y4" cabinet
hole to the dishwasher location. The cable must extend
24" from the back wall.
The hole cut through a wood cabinet should be sanded
until smooth.
The hole cut through a metal cabinet must be covered
with a grommet (Part No. 302797), available from your
dealer or parts supplier.
A U.L.-listed strain relief or conduit connector must
be installed at each end of the power supply cable
(at the dishwasher and at the junction box). Wire sizes
(COPPER WIRE ONLY) must conform with the rating
of the dishwasher.
(continued)
3369671-C