Whirlpool Dishwasher Manuel d'utilisation

Page 11

Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".

Advertising
background image

3. Bow color panel with desired color facing out and insert

into access panel frame. Slide color panel down into
groove along bottom of access panel frame.

4. Line up ends of top trim with sides of access panel

frame. Slide top trim in while tilting the back of trim down.
Snap front of top trim down to cover the top edge of
access panei.

To install customized wood panels

In door and access panel

Dishwasher door panel and access panel (if modei is so

equipped) can be customized to match wood cabinets to
match wood cabinets. A %2" inch thick wood panel would
need to be cut to the dimensions as specified in Step 1.
Wood paneis thicker than %2" wood need to be cut to a
width of 23“ and the top and bottom routed to 732" thickness.

Follow dimension specifications carefully.

It is recommended that a cabinetmaker cut the customized

front panel because of the precise cuts needed.

y-a"

(.6 cm) Thick-

Top view

Cut accurately
for snug fit
between door
side frames
as shown.

Wood
access
panel >

Access
panel

frame

File or sand edges

of wood panel to

avoid slivers.

18’%2" (47.2 cm)

(11.3 cm)

(.6 cm)

Thickness

1. Cut wood for door and access panel using specified

dimensions. Make sure wood grain matches direction of
cabinet wood grain.

2. File or sand edges of wood panels.

Dishwasher is subject to some humidity. Cover
both sides and edges of wood panels with moisture
resistant sealer.

3. Push up at each end of the trim piece at bottom of door

panel. Then pull trim piece toward you. Set trim piece
aside.

4. Use one hand to push door panel(s) and spacer panel

up. Use other hand to bow bottom edge of door panel(s).
Remove door panel(s) and spacer panel from door. Save

door panel(s) and spacer panel for future use.

5. Insert top of wood panel between sides of frame. Slide

top of panel upward under bottom edge of control con­
sole. Press lower portion of wood panel between sides
of door frame.

Control console

Slide top
of panels
and spacer
under control
console.

6. Lift door panel up and hold with one hand.

(continued)

3369671-C

1 1

Advertising