Cadillac 2012 Escalade Manuel d'utilisation

Page 360

Advertising
background image

Black plate (60,1)

Cadillac Escalade/Escalade ESV Owner Manual - 2012 - 2nd CRC - 11/29/11

9-60

Driving and Operating

The tow/haul mode may be used if
the transmission shifts too often.
See Tow/Haul Mode on page 9‑33.

When towing at high altitude on
steep uphill grades, consider the
following: Engine coolant will boil at
a lower temperature than at normal
altitudes. If the engine is turned off
immediately after towing at high
altitude on steep uphill grades, the
vehicle may show signs similar to
engine overheating. To avoid this,
let the engine run while parked,
preferably on level ground, with the
automatic transmission in P (Park)
for a few minutes before turning the
engine off. If the overheat warning
comes on, see Engine Overheating
on page 10‑19
.

Parking on Hills

{

WARNING

Parking the vehicle on a hill with
the trailer attached can be
dangerous. If something goes
wrong, the rig could start to move.
People can be injured, and both
the vehicle and the trailer can be
damaged. When possible, always
park the rig on a flat surface.

If parking the rig on a hill:

1. Press the brake pedal, but do

not shift into P (Park) yet. Turn
the wheels into the curb if facing
downhill or into traffic if facing
uphill.

2. Have someone place chocks

under the trailer wheels.

3. When the wheel chocks are in

place, release the regular brakes
until the chocks absorb the load.

4. Reapply the brake pedal. Then

apply the parking brake and shift
into P (Park).

5. Release the brake pedal.

{

WARNING

It can be dangerous to get out of
the vehicle if the shift lever is not
fully in P (Park) with the parking
brake firmly set. The vehicle
can roll.

If the engine has been left
running, the vehicle can move
suddenly. You or others could be
injured. To be sure the vehicle will
not move, even when on fairly
level ground, always put the shift
lever fully in P (Park) with the
parking brake firmly set.

Leaving After Parking on a Hill

1. Apply and hold the brake pedal.

2. Start the engine.

3. Shift into a gear.

Advertising