Retained accessory power (rap), Shifting into park, Retained accessory – Cadillac 2012 Escalade Manuel d'utilisation

Page 326: Power (rap) -26, Shifting into park -26, Locking, 26 driving and operating

Advertising
background image

Black plate (26,1)

Cadillac Escalade/Escalade ESV Owner Manual - 2012 - 2nd CRC - 11/29/11

9-26

Driving and Operating

3. Plug the cord into a normal,

grounded 110-volt AC outlet.

{

WARNING

Plugging the cord into an
ungrounded outlet could cause an
electrical shock. Also, the wrong
kind of extension cord could
overheat and cause a fire. You
could be seriously injured. Plug
the cord into a properly grounded
three-prong 110-volt AC outlet.
If the cord will not reach, use a
heavy-duty three-prong extension
cord rated for at least 15 amps.

4. Before starting the engine, be

sure to unplug and store the
cord as it was before to keep it
away from moving engine parts.
If you do not, it could be
damaged.

The length of time the heater should
remain plugged in depends on
several factors. Ask a dealer in the
area where you will be parking the
vehicle for the best advice on this.

Retained Accessory
Power (RAP)

The following vehicle accessories
can be used for up to 10 minutes
after the engine is turned off:

.

Audio System

.

Power Windows

.

OnStar System (if equipped)

.

Sunroof (if equipped)

These features work when the key
is in ON/RUN or ACC/
ACCESSORY. Once the key is
turned from ON/RUN to LOCK/OFF,
the windows and sunroof continue
to work up to 10 minutes until any
door is opened. The radio continues
to work for up to 10 minutes or until
the driver door is opened.

Shifting Into Park

{

WARNING

It can be dangerous to get out of
the vehicle if the shift lever is not
fully in P (Park) with the parking
brake firmly set. The vehicle can
roll. If you have left the engine
running, the vehicle can move
suddenly. You or others could be
injured. To be sure the vehicle will
not move, even when you are on
fairly level ground, use the steps
that follow. If you are pulling a
trailer, see Driving Characteristics
and Towing Tips on page 9‑57
.

1. Hold the brake pedal down, then

set the parking brake.

2. Move the shift lever into the

P (Park) position by pulling the
shift lever toward you and
moving it up as far as it will go.

3. Turn the ignition key to

LOCK/OFF.

Advertising