Panasonic WV-BL730 - Manuel (Page 33)

9. Special Menu (SPECIAL)
This menu lets you adjust and set up the video signal
of the camera to meet your requirements.
Move the cursor to END on the bottom line of the CAM
SET UP menu and press ^ or simultaneously for
2 seconds or longer. The SPECIAL menu appears on
the monitor as shown below.
f
** CAM SET UP
CAMERA ID OFF 1
AI£/ELC ALC T
SHUTTER OFF
AGC OR
SENS UP OFF
SYNC INT
HOTIOK DBT OFF
LEES DRIVE DC
SET UP QIABLE
______ /
UP SZim DONH OFF
AP GAZn ------ 1.
PEOIESTAI. .1_____
CAMERA RESETi
9-1. Camera Picture Upside Down Positioning
(UP SIDE DOWN)
1. Move the cursor to the UP SIDE DOWN parameter.
2. Select ON when you want to turn the picture
upside down.
9-2. Aperture Gain Setting (AP GAIN)
1. Move the cursor to the AP GAIN parameter.
2. While observing the vector scope or video monitor,
move the "I”.cursor to adjust the aperture gain
level.
9-3. Pedestal Level Setting (PEDESTAL)
1. Move the cursor to the PEDESTAL parameter.
2. While observing the wave form monitor/osciNo-
scope or video monitor,' move the “I" cursor to
adjust the pedestal level (black level).
To reset to the factory settings
1. Move the cursor to the CAMERA RESET parame-*
ter. The words PUSH SW start blinking.
2. While holding down ^ and , press E3 for 2
seconds or longer. The camera is reset to the fac­
tory settings.
To close the SPECIAL menu and return to the CAM
SET UP menu
Move the cursor to RET and press EJ •
To close the SPECIAL menu and return to the
camera picture
Move the cursor to END and press O.
-
31
-