Panasonic WV-BL730 - Manuel (Page 19)

• Opening the Setup Menu
Press and hold down [HJ for a second or longer.
•* CMI SET DP
CAHERA ID
ALC/ELC
ALC T
SHUTTER OFF
AGC ON
SEES DP OFF
SYBC HIT
HOTIOB DET OFF 1
LESS DRIVE DC
eud SET DP DISABLE
'Blinking
The CAM SET UP menu appears on the monitor as
shown above.
Check the current settings on the menu.
Refer to the sections below for a detailed description of
menu items. If you decide not to make any changes
after checking the current settings, move the cursor to
END at the start of the bottom line, and press 1=3 to
'Close the CAM SET UP menu and return to normal
camera picture mode.
Note: If no button is pressed for 6 minutes while the
CAM SET UP menu or any other setting menu is
displayed, displaying the menu is automatically
canceled and the mode returns to the normal cam­
era picture.
f N
** CAM SET DP
CAMERA ID OFF “1
ALC/ELC ALC T
SHUTTER OFF
AGC ON
SSIS DP OFF
SYNC HIT
nOTION DET OFF 1
LENS DRIVE DC
Haro SET DP DISABLE
V
_____
• Editing the CAM SET UP Menu
Important Notice:
When the words SET UP DISABLE appear on the
bottom line of the CAM SET UP menu, you cannot
change the currently active settings. This is to pre­
vent accidental changing of the settings.
To edit the CAM SET UP menu (change settings), use
(®l and t&J or -Q and to move the cursor to SET
UP DISABLE in the bottom line.
Press E]. SET UP DISABLE changes to SET UP
ENABLE. Move the cursor to END, then to the item(s)
you want to change.
-
17
-