Panasonic WV-BL730 - Manuel (Page 29)

6-1. vs Gen-lock Mode (EXT(VS))
1. Move the cursor to the SYNC parameter and
select I NT.
2. Connect the coaxial cable for the composite sync
or composite B/W video signal to the gen-lock
input connector.
3. Confirm that the parameter I NT changed to EXT
(VS) on the menu.
Caution: The gen-lock input signal should meet
with EIA RS-170 specifications and should not
contain jitter, such as a VCR playback signal,
as it could disturb synchronization.
r
** CJUi SET DP
САНЕЯЛ ID OFF T
ЛЬС/ЕЬС AXC "1
SHUNTER OFF
лес OB
SENS DP OFF
ЗУЯС jcm
HOTIOH DET OFF “1
Т.ЯМЯ nRXVE DC
EHD SET DP ЕВЛВЬЕ
Ч____________
f
•• СЛН SET DP **
СЛНЕНА ZD OFF “1
ЛЬС/ELC ALC ~1
SEOnER OFF
AGC OB
SEBS UP OFF
SYNC ED(VS)
HOTZOB OBT OFF 1
bEBS DRIVE DC
EBD SET DP EKABXJS
V________
4. After confirming the cursor is on EXT (VS), press
El. The phase adjustment menu appears on the
monitor.
5. Move the cursor to H PHASE. The cursor starts
blinking.
6. Supply the video output signal of the camera to be
adjusted and the reference gen-lock input signal
to a dual-trace oscilloscope.
7. Set the oscilloscope to the horizontal rate and
expand the horizontal sync portion on the oscillo­
scope.
8. Adjust the horizontal phase by pressing ^ or
. The adjustable range is 0 - 2.0ps.
6-2. Line-lock Sync Mode (LL)
Note: The line-lock (LL) sync mode is not available
when the camera operates on DC power,
1. Move the cursor to the SYNC parameter and
select LL.
Note: The settings in this menu can be made only
when the multiplexed vertical drive signal
(VD2) is not supplied to the camera.
-
27
-