Krampouz Fest Noz - Manuel (Page 7)

7 -
On receipt of the parcel and when opening
Any damage caused during transport must be reported to the shipping agent by recorded delivery letter
within 24 hours of receiving the parcel.
Working environment
1. Choose a work surface made of stainless steel or any other material which complies with hygiene
standards and which is heat resistant.
2. Any units or walls in contact with the appliance must be heat resistant.
3. The recommended height for installation of the griddle is 85 to 95 cm from the floor, which gives the
best working position.
4. The base of the appliance must have adequate ventilation to allow sufficient air supply around the
burner.
5. Avoid draughty locations.
6. Ensure that there is no obstruction above the griddles.
7. The crepe makers must be used close to an air extraction system (air flow needed: approximately 200
m³/h/griddle).
8. The space between the griddle and the frame must not be blocked.
Connecting up
The appliance should be connected to the gas supply with a flexible tube in accordance with current
standards and regulations.
Our appliances must be installed by technicians or engineers suitably qualified for carrying out gas
installations.
KRAMPOUZ shall not be held responsible for any bodily harm or damage to goods due to incorrect
installation or use of the appliance.
The configuration of the gas supply for the appliance is indicated on the identification plate stuck to the
frame or air ring.
Ignition
1 Once the appliance has been fully installed and is ready for to be used, check that the gas supply tap
is open.
2 When igniting for the first time after installation, turn the knob, place it on maximum setting and hold it
pressed in for 5 seconds to allow the air to flow from the gas pipe to the burner. Then release the knob.
3 Open the gas tap by turning the knob to the left, set it to maximum.
4 Strike a match and slip it between the griddle and the frame.
5 Release the knob and allow the burner to heat up for 3 to 4 minutes, then set the knob on position 1
(slow setting mode or small flame).
6 Your appliance is now ready for use.
Using the crepe maker
Seasoning of the griddle
This operation (lasting 1 to 1 ½ hour) is necessary when griddles are new. Its purpose is to make removal of
the crepes easier and to reduce bubbling of the batter when in contact with the griddle.
Once your appliance is connected to the gas supply and the griddle plate is in position, proceed as
follows: