MARVEL Scientific MPRO30iMT - Manuel (Page 18)

NOTE
4. Remove the drain plug at the bottom of the reservoir to
drain any remaining water and then reinstall.
5. Allow the ice to fall from the evaporator, remove and dis-
card slab of ice. (See figures 21 and 22).
6. Determine the proper amount of cleaner from the ice ma-
chine cleaner manufacturer’s mixture ratio based on 3/4 gallon
(2.81 liters) of water (refer to the manufacturer’s mix ratio
directions). Add the recommended amount of concentrated
cleaning solution to the reservoir of the ice machine. This can
be done by pouring the solution on the evaporator, which will
flow down into the reservoir. (See figure 23).
7. Switch the selector switch on the grille of the ice machine to
the “CLEAN” position. The ice machine will automatically
start and stop the cleaning cycle and ¾ of a gallon (2.81 liters)
of water will automatically be added to the cleaning solu-
tion.
8. The total cleaning time will end in 49 minutes. The cleaning
cycle will automatically rinse the evaporator plate and also
drain the cleaning solution and rinse the reservoir with water.
9. After the cleaning cycle has ended check that the build-up has
been removed. The evaporator plate should be clean, shiny,
and smooth to the touch. If build-up is still visible, repeat the
cleaning cycle above.
10. Clean the ice machine’s interior, ice scoop, interior door
panel and door gasket with mild soap and water. Using two (2)
tablespoons of baking soda in one (1) quart of warm water
while cleaning will help remove odors. Rinse with fresh water.
DO NOT USE ANY ABRASIVE CLEANING PRODUCTS.
11. Replace the front panel.
12. Your ice machine is now clean and sanitized and may be put
back into operation by switching the selector switch to the
“ON” position.
Drain plug
in bottom of
reservoir.
Figure 20
Figure 23
Discard the first batch of ice.
In the unlikely event a power
interrupt occurs during the clean cycle, you need to start over
from the beginning to assure complete cleaning and rinsing of
the cleaning agent from the machine.
18
OPERATION, CARE, AND CLEANING OF YOUR ICE MACHINE
Figure 21
Allow ice slab
to fall on to grid
cutter
Figure 22
Remove ice
slab and
discard