Philips Blender - Manuel (Page 6)

6
introduction
Congratulations on your purchase and welcome to Philips! To fully benefit from the support that
Philips offers, register your product at www.philips.com/welcome.
important
Read this user manual carefully before you use the appliance and save it for future reference.
general
danger
- Never immerse the motor unit in water or any other liquid, nor rinse it under the tap. Use only
a moist cloth to clean the motor unit.
Warning
- Check if the voltage indicated on the appliance corresponds to the local mains voltage before
you connect the appliance.
- If the mains cord is damaged, you must have it replaced by Philips, a service centre authorised by
Philips or similarly qualified persons in order to avoid a hazard.
- Do not use the appliance if the plug, the mains cord or other parts are damaged.
- Never use the blender jar or mill beaker to switch the appliance on and off.
- Never let the appliance run unattended.
- This appliance is not intended for use by persons (including children) with reduced physical,
sensory or metal capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their
safety.
- Children should be supervised to ensure that they do not play with the appliance.
- Do not touch the blades, especially when the appliance is plugged in. The blades are very sharp.
- If the blades get stuck, unplug the appliance before you remove the ingredients that block the
blades.
- Never place the blade unit onto the motor unit if the blender jar or mill beaker (specific types
only) is not or not properly attached to it.
Caution
- Always unplug the appliance before you assemble, disassemble or make adjustments to any of
the parts.
- Never use any accessories or parts from other manufacturers or that Philips does
not specifically recommend. If you use such accessories or parts, your guarantee becomes
invalid.
- Noise level: Lc = 86 dB(A)
Blender
Warning
- Never reach into the blender jar with your fingers or an object while the appliance is running.
- Make sure the blade unit is securely fastened to the blender jar before you assemble the
blender jar onto the motor unit.
Caution
- Never fill the blender jar with ingredients hotter than 80ºC.
- To prevent spillage, do not put more than 1.5 litres of liquid in the blender jar, especially when
you process at a high speed. Do not put more than 1 litre in the blender jar when you process
hot liquids or ingredients that tend to foam.
- If food sticks to the wall of the blender jar, switch off the appliance and unplug it. Then use a
spatula to remove the food from the wall.
EnglisH