NaceCare Solutions ETB1120 - Manuel (Page 8)

8
Using the handle position lever
(Fig 1), move the handle into the
upright position. (Fig 2).
PLEASE READ BEFORE COMMENCING ANY OPERATION.
After the removal of all the packaging, carefully open and check the contents.
Ensure the Batteries are charged before use.
! !
1
4
5
Fit the isolator key and switch the machine on (Fig 7).
Fig 1
Quick Set-Up Guide
2
Fig 3
Place the top tank (waste water) into the machine (Fig 5) and connect the
vacuum and floor tool hose to the separator (Fig 6).
3
Fig 5
Fill the bottom tank (Clean Water) from a tap or hose pipe using the Flexi-Fill pipe fitted to
the filler cap (Fig 8). Add Non foaming cleaning fluid as required (See page 11).
The ETB 1120 has a water capacity of 11 gal
Fig 2
Fig 4
Fig 6
Fig 7
Fig 8
Note:
Great care must be taken to ensure that contaminants
(leaves, hair, dirt, etc.) are not allowed to enter the
clean-water tank during the filling process.
If using a bucket or similar, ensure it is always clean
and free from debris.
Connect 24V power supply to
the machine