NaceCare Solutions ETB1120 - Manuel (Page 17)

17
577877 Top Tank - Red 208638 Wheel
577878 Bottom Tank - Red 577812 Deck
577839 Separator 577892 Handle
206265 Barrel Filter 321686 Vac Motor
207000 Basket Filter 208588 Vac Hose
206698 Floor Tool Hose 221107 50 Amp Fuse (Batteries)
213047 Dump Hose Top 206813 Isolator Pin \ Key
303641 Dump Hose Bottom 229295 Floor Tool Retaining Pin
606309 Floor Tool 206953 Detent Pin
606028 Polyscrub Brush 20” 606551 Long Life Brush 20”
606550 Nyloscrub Brush 20” 606403 Padloc Drive Board 20”
606037 Recommended floor tool Blade Set 606071 Replacment Polyurethane Blade Set (optional)
ETB 1120
Brush Motor Vac Motor Brush Sizes
Pad
sizes
Weight
Protection
Class
Power
400W 400W 20’’ 20’’ 335 lbs IPX4 2 x 12V (24V) 100Ah
Fluid Flow Speed Cleaning Speed Hand Arm Vibration Noise Size
0.53 gpm
100 rpm
0 - 0.31mph 0.57 m/s 2
Hi-69 dB(A)
Lo-67 dB(A)
Width - 22’’
Length - 40.5’’
Height - 45.6’’
PROBLEM CAUSE SOLUTION
Machine will not operate Missing or blown fuses
Battery not connected
Low battery charge Fit or replace fuse
Connect battery
Charge batteries (page 16)
Vacuum will not operate Vacuum not turned on Turn on vacuum (page 13)
Poor water pick-up Waste-water tank full
Clogged / blocked vacuum hose
Loose hose connections
Debris basket filter clogged/blocked
Separator filter clogged / blocked
Poor separator seal
Damaged separator seal
Damaged / split vacuum hose
Damaged floor-tool blades
Low battery charge Empty waste-water tank (page 14)
Remove and clean (page 14)
Push tight connections (page 14)
Remove and clean (page 14)
Remove and clean (page 14)
Clean and refit (page 14)
Renew (contact service dept)
Renew (contact service dept)
Renew (contact service dept)
Recharge batteries
No brush / scrub function No brushes fitted
Brush overloaded Check and fit (page 10)
Reset machine (page 13)
Little or no water flow Clean-water tank empty
Clean-water tank filter blocked/ clogged
Clean water tap not turned on Fill clean-water tank (page 11)
Remove and clean (page 14)
Turn on clean water tap (page 9)
Machine just ‘stops’ while
operating Too much load on the brush system
Blown fuse
Reset the machine and decrease the
brush load to best suit the floor type
(page 13)
Replace fuse
Trouble Shooting