Napoleon Fireplaces FIBERGLOW GL18E - Manuel (Page 11)

11
W415-1071 / C / 01.11.12
4.6 OPTIONAL ROCK PLACEMENT
!
WARNING
REAL ROCKS MUST NOT BE USED IN THIS APPLIANCE. HEAT WILL CAUSE THEM TO EXPLODE
A. Begin with thin rock clusters on rear log support, then build outward in a pattern as shown. Removing a
locating pin in the rear support may be required to accommodate the rock clusters. It is not necessary
to use all of the rocks.
IMPORTANT: Do not block burner ports on burner surface. Do not block slots beneath or behind the
andirons.
4.7 OPTIONAL REMOTE INSTALLATION (NOT SUPPLIED)
A. The remote receiver must be installed onto the bracket on the back right sides of the burner.
B. Bend the tab on the bracket straight and then using the double sided tape supplied with the remote kit,
adhere the remote reciever to the bracket.
C. Hook up the wires from the remote receiver to the green and white wires on the wire harness.