Napoleon Fireplaces GDI30G - Manuel (Page 21)

21
W415-0832 / C / 06.07.12
A. Remove the glass media and media tray, see "MEDIA TRAY
INSTALLATION" section.
B. Remove the 2 screws holding the lamp assembly shield.
C. Compress the 3 retainer fi ns and lift out the lamp assembly. Disconnect
the wires.
D. Replace lamp assembly by aligning key hole and snap into place. Re-
connect the wires.
E. Re-install the lamp assembly shield.
F. Re-install media tray and glass media.
NOTE: When removing the media tray make sure the glass media is away
from the center of the screen, exposing the burner, before lifting media tray
out.
When replacing burner, absolutely no glass media can be in cup surrounding the
orifi ce. HINT: If glass falls into cup and surrounds the orifi ce, insert a clean
bag into a vacuum cleaner and vacuum out glass media. Replacement glass
media can be ordered from Wolf Steel Ltd.
10.2 LAMP ASSEMBLY REPLACEMENT
THE FRONT OF THE APPLIANCE BECOMES VERY HOT DURING OPERATION. LET THE APPLIANCE
COOL COMPLETELY BEFORE CONDUCTING SERVICE.
!
WARNING
KEY HOLE
RETAINER
FINS
LAMP ASSEMBLY
SHIELD
A. Place the door frame face down careful not to scratch the
paint.
B. Center the gasketed glass inside the door frame with the thick
side of the gasket facing up.
C. Bend the glass retainers located along the edge of the door
frame over the gasket holding the glass in place. Careful not
to break the glass.
!
WARNING
DO NOT USE SUBSTITUTE MATERIALS.
GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.
CARE MUST BE TAKEN WHEN REMOVING AND DISPOSING OF ANY BROKEN DOOR GLASS OR
DAMAGED COMPONENTS. BE SURE TO VACUUM UP ANY BROKEN GLASS FROM INSIDE THE
APPLIANCE BEFORE OPERATION.
DO NOT STRIKE, SLAM OR SCRATCH GLASS. DO NOT OPERATE APPLIANCE WITH GLASS
REMOVED, CRACKED, BROKEN OR SCRATCHED.
56.1A
GLASS
GASKET
DOOR
FRAME
GLASS
RETAINER
10.3 DOOR GLASS REPLACEMENT