Napoleon Fireplaces EPA 1100 - Manuel (Page 20)

20
W415-0763 / B / 10.28.11
Insert the ornamental trivet into the space on the stove top.
TRIVET
Ensure that the pedestal surfaces are clean and dry; peel the protective backing from the trim adhesive. Insert
one end of the brass trim into one of the slots located in the pedestal and pressing fi rmly, proceed around
to the other slot. Cut trim to size. Attach the rear knockout plate (located inside the ash pan for shipping
purposes).
TRIM
PEDESTAL
KNOCKOUT
PLATE
5.3 ORNAMENTAL TRIVET INSTALLATION
5.4 PEDESTAL TRIM INSTALLATION (IF SUPPLIED)
5.5 BRICKS AND BAFFLE INSTALLATION
!
WARNING
OPERATIION OF THE APPLIANCE WITHOUT THE BAFFLES CAN RESULT IN EXCESSIVE
TEMPERATURES THAT COULD DAMAGE THE APPLIANCE, CHIMNEY AND THE
SURROUNDING ENCLOSURE.
With appliance and chimney installation completed, move the bricks into place for your appliance as
illustrated.
A. Install the bottom bricks, working from the back of the appliance forward.
B. Before installing the back bricks, loosen the screw holding the brick retainer and insure that it has
been moved forward. Install the six bricks along the back wall by pivoting the bricks up under the brick
retainer. Re-tighten the screw.
C. Referring to the appropriate illustration for your appliance, install the fi rst two rows of side bricks as
shown. Pivot the fi bre baffl e into place with the brick retainter down and toward the outside of the unit.
Slide the top row of bricks into place to support the baffl e. The baffl e must sit fl at on the outside row of
bricks as well as the fl ange on the manifold shield. Push the baffl e all the way to the rear of the fi rebox,
leaving a minimum of 1” gap along the front. This will allow fl ue gases to escape the fi rebox.
D. Install the 4 bricks along the front opening.
NOTE: Do not operate if baffl e and manifold shield are not in position.