Napoleon Fireplaces 1600C-1 Manuel d'utilisation

Page 11

Advertising
background image

W415-0721 / B / 05.03.11

11

4.1.1 CHIMNEY CONNECTION

This appliance must be connected to:
A.

A chimney complying with the requirements for Type
HT chimneys in the Standard for Chimneys, Factory-
Built, Residential Type and Building Heating Appli-
ance, or

B.

A code-approved masonry chimney with a fl ue liner.
Vent the stove into a masonry chimney or an ap-
proved, insulated solid-fuel stainless-steel chimney
with as short and straight a length of 6” diameter

chimney connector as possible. Connection to a ma-

sonry chimney must be by a metal or masonry thimble
cemented in place.

TOWARD
APPLIANCE

FLUE GAS
DIRECTION

MALE END OF
CONNECTOR
OR CHIMNEY
PIPE

58.1A

Your chimney connector and chimney must have the same diameter as the appliance’s exhaust outlet. The
appliance pipe must be made of aluminized or cold roll steel with a minimum 24 gauge thickness. It is strictly
forbidden to use galvanized steel.

For installation of your chimney connector, the following recommendations may be useful.

The pipe must be short and straight. For optimum performance it is recommended that all horizontal
runs have a minimum 1/4” rise per foot, with the upper end of the section toward the chimney. For safe
and proper operation of the appliance, see “INSTALLATION” instructions.

To insure a good draft, the total horizontal length of the connector should never exceed 8’ to 10’. In
the case of vertical installation, the total length of the connector can be longer and connected without
problem to the chimney at the ceiling level.

There should never be more than two 90° elbows in the whole connector and chimney system. Never
start with a 90° elbow. Always go up vertically for at least 2 feet from the fl ue before using a 90° elbow.

The connector must not pass through any combustible material, nor may it pass through a concealed
space (such as an attic, roof space, or closet). If passing through a wall, ceiling, or into a masonry
chimney, use either chimney components listed for that specifi c use, or means acceptable to local
authorities having jurisdiction over the installation.

Advertising