Napoleon Fireplaces Ascent Multi-View - BHD4 - Manuel (Page 39)

W415-1285 / 04.14.14
39
EN
!
WARNING
FAILURE TO POSITION THE LOGS IN ACCORDANCE WITH THESE DIAGRAMS OR FAILURE TO USE
ONLY LOGS SPECIFICALLY APPROVED WITH THIS APPLIANCE MAY RESULT IN PROPERTY
DAMAGE OR PERSONAL INJURY.
LOGS MUST BE PLACED IN THEIR EXACT LOCATION IN THE APPLIANCE. DO NOT MODIFY THE
PROPER LOG POSITIONS, SINCE APPLIANCE MAY NOT FUNCTION PROPERLY AND DELAYED
IGNITION MAY OCCUR.
THE LOGS ARE FRAGILE AND SHOULD BE HANDLED WITH CARE.
76.1A
Phazer TM logs and glowing embers exclusive to Wolf Steel Ltd., provide
a unique and realistic glowing effect that is different in every installation.
During the initial use of the appliance, log colours may vary. During the
initial use of the appliance the colours will become more uniform as colour
pigments burn in during the heat activated curing process.
NOTE: The pilot is located on the right end in these instructions.
1. Remove the doors, refer to the "DOOR REMOVAL / INSTALLATION
section for removal instructions.
2. Place a pin into the bottom of log #1 lining it up with the hole in the
hearth pad. Then place onto the screw and spacer located in the
corner of the burner, on the right side. Place a pin into the center of
log #1, as shown in Figure 1.
3. Place log #2 onto the pin located in the log #1, it should rest in the
middle of the left side hearth pad as shown in Figure 2. Place one pin
into the middle of log #2, as shown in Figure 2.
4. Place log #3 onto the pin located in log #2 and let it rest on log #2, as
shown in Figure 3 and in the left side view below. Place another pin
into log #2, as shown in Figure 3.
5. Place log #4 onto the pin located in log #2 and let it rest on log #2, as
shown in Figure 4 and in the left side view. Place one pin into the left
side hearth pad, as shown in Figure 4.
6. Place log #5 onto the pin located in the left side hearth pad and let it
rest on the burner, as shown in Figure 5. NOTE: Ensure log #5 does
not cover any burner ports.
7. Place log #6 onto the pin located on the right side corner of the
burner, then place one pin into middle of the log #6 and log #5, as
shown in Figure
6. NOTE: Ensure log #6 does not cover any
burner ports.
6.7 LOG PLACEMENT
p p p p
LEFT SIDE VIEW
1
2
3 4 5
6
7
8
10
NOTE: The individual logs can be easily identifi ed by the numbers cast on the underside of each log.
Fig. 5
Fig. 1 PIN
Fig. 3
PIN
Fig. 4
PIN
Fig. 6
PIN
Fig. 2
PIN
11
PIN