Napoleon Fireplaces B30NTR - Manuel (Page 41)

41
W415-1296 / 05.20.14
EN
C. Position the right log (W135-0577) onto the
two studs located on the right side of the log
support. Place one pin into the hole located
on the top of the right log. D. Place the left crossover log (W135-0578) onto
the pin located in the left side of the rear log,
allow it to rest in the notch of the left log.
B
A
C
B
A
C
D
6.2 LOG PLACEMENT
PHAZER TM logs and glowing embers exclusive to Napoleon, provide a unique and realistic glowing effect that is
different in every installation. Take the time to carefully position the glowing embers for a maximum glowing effect.
Log colours
may vary. During the initial use of the appliance, the colours will become more uniform as colour
pigments burn in during the heat activated curing process.
A. Place the rear log (W135-0575) fi rmly onto
the two studs at the rear of the support tray.
Ensure the log sits fl at and does not cover
the pilot opening. Place two pins in the holes
located on the top rear of the rear log.
B. Place the left log (W135-0576) onto the two
studs located on the left side of the log support.
!
WARNING
FAILURE TO POSITION THE LOGS IN ACCORDANCE WITH THESE DIAGRAMS OR FAILURE TO USE
ONLY LOGS SPECIFICALLY APPROVED WITH THIS APPLIANCE MAY RESULT IN PROPERTY
DAMAGE OR PERSONAL INJURY.
LOGS MUST BE PLACED IN THEIR EXACT LOCATION IN THE APPLIANCE. DO NOT MODIFY THE
PROPER LOG POSITIONS, SINCE APPLIANCE MAY NOT FUNCTION PROPERLY AND DELAYED
IGNITION MAY OCCUR.
THE LOGS ARE FRAGILE AND SHOULD BE HANDLED WITH CARE.
76.1A
B
A
A
PINS
PIN