Sony MEX-BT3000P - Manuel (Page 22)

22
Sound Settings and
Setup Menu
Changing the sound
settings
Adjusting the sound
characteristics
1
During reception/playback, press the
select button.
2
Rotate the control dial until the desired
menu item appears, then press it.
3
Rotate the control dial to select the
setting, then press it.
4
Press (BACK).
The following items can be set:
*1 When EQ3 is activated (page 23).
*2 When the audio output is set to “SUB-OUT”
(page 23).
“ATT” is displayed at the lowest setting, and
can be adjusted up to 21 steps.
*3 When AUX source is activated (page 24).
*4 When Bluetooth audio source is activated.
Selecting the sound quality
— EQ3 Preset
You can select an equalizer curve from 7
equalizer curves (XPLOD, VOCAL, EDGE,
CRUISE, SPACE, GRAVITY, CUSTOM or
OFF).
1
During reception/playback, press the
select button.
2
Rotate the control dial until “EQ3
PRESET” appears, then press it.
3
Rotate the control dial until the desired
equalizer curve appears, then press it.
4
Press (BACK).
To cancel the equalizer curve, select “OFF”
in step 3.
Tip
The equalizer curve setting can be memorized for
each source.
EQ3 PRESET (page 22)
EQ3 LOW * 1 (page 23)
EQ3 MID * 1 (page 23)
EQ3 HIGH * 1 (page 23)
BALANCE
Adjusts the sound balance: “RIGHT-15”
– “CENTER” – “LEFT-15.”
FADER
Adjusts the relative level: “FRONT-15” –
“CENTER” – “REAR-15.”
SW LEVEL (Subwoofer Level)* 2
Adjusts the subwoofer volume level:
“+10 dB” – “0 dB” – “–10 dB.”
(“ATT” is displayed at the lowest
setting.)
AUX VOL (AUX Volume level)* 3
Adjusts the volume level for each
connected auxiliary equipment: “+18
dB” – “0 dB” – “–8 dB.”
This setting negates the need to adjust
the volume level between sources.
BTA VOL (Bluetooth Audio Volume
Level)* 4 (page 19)