Sony MEX-BT3000P - Manuel (Page 15)

15
cellular phone name appear in the
display.
Icons in the display:
* Turns off without handsfree connection.
Differs in the case of a cellular phone.
Changing display items
Press
.
Connecting the last-connected cellular
phone from this unit
1
Make sure the Bluetooth signal of the
cellular phone is activated.
2 Press
 repeatedly until “BT
PHONE” appears.
3
Press (handsfree).
“ ” flashes while the connection is
being made, then stays lit while
connected.
Notes
• Some cellular phones require permission to
access their phonebook data during handsfree
connection to this unit. Obtain permission via
the cellular phone.
• While streaming Bluetooth audio, you cannot
connect from this unit to the cellular phone.
Connect from the cellular phone to this unit
instead. A connecting noise may be heard over
playback sound.
Tip
With Bluetooth signal on: when the ignition is
turned to on, this unit reconnects automatically
to the last-connected cellular phone. But
automatic connection also depends on the
cellular phone’s specification. If automatic
connection is not made, connect manually.
Connecting an audio device
1
Press
 and rotate the control
dial until “SET BT SIGNL” appears,
then press it.
“
” lights up when Bluetooth signal is
activated.
2
Turn on the audio device and activate
the Bluetooth signal.
3
Connect to this unit using the audio
device.
“
” appears when the connection is
made.
Connecting the last-connected audio
device from this unit
1 Make sure the Bluetooth signal of the audio
device is activated.
2 Press
 repeatedly until “BT
AUDIO” appears.
3 Press
 (PAUSE).
“ ” flashes while the connection is
being made, then stays lit while
connected.
Handsfree calling
Once the unit is connected to the cellular
phone, you can make/receive handsfree
calls by operating this unit.
Before handsfree calling, check the
following:
Signal strength status of
connected cellular phone.*
Remaining battery status of
connected cellular phone.*