Pairing – Sony MEX-BT3000P Manuel d'utilisation
Page 13
13
* For SET PAIRING, REDIAL, VOICE DIAL and
SET BT SIGNL settings, step 3 is not necessary.
The following items can be set:
* Depending on the cellular phone, this unit’s
ringtone may be output even if set to “2 (cellular
phone).”
Pairing
The Bluetooth device (cellular phone, audio
device, etc.) and this unit need to be
“paired” before use between each other via
the Bluetooth function.
Tips
• For details on pairing for a Bluetooth device,
refer to the operating instructions supplied with
the device.
• You can pair up to 9 Bluetooth devices with this
unit.
1
Place the Bluetooth device within 1 m
(3 ft) of this unit.
2
Press
and rotate the control
dial until “SET PAIRING” appears,
then press it.
The unit enters pairing standby mode.
3
Set the Bluetooth device to search for
this unit.
A list of detected devices appears in the
display of the device to be connected.
This unit is displayed as “Sony
Automotive” on the device to be
connected.
4
If passkey* input is required in the
display of the device to be connected,
input “0000.”
If the device supports Bluetooth version
2.1, passkey input is not required.
* Passkey may be called “passcode,” “PIN
code,” “PIN number” or “Password,” etc.,
depending on the device.
This unit and the Bluetooth device
memorize each other’s information, and
when pairing is made,
stays lit.
SET PAIRING
PHONEBOOK
REDIAL
RECENT CALL
VOICE DIAL
DIAL NUMBER
RINGTONE
*
Selects whether this unit or the
connected cellular phone outputs the
ringtone: “1 (this unit)”- “2 (cellular
phone).”
AUTO ANSWER
Sets this unit to answer an incoming call
automatically: “OFF”-“1 (about 3
seconds)”-“2 (about 10 seconds).”
SET BT SIGNL
(Set Bluetooth Signal)
Flashing
Input passkey
“0000”