Ports de communication – HP Logiciel HP Matrix Operating Environment Manuel d'utilisation
Page 40
com.hp.gwlm.util.Log.logFileSize = 20
com.hp.gwlm.util.Log.logNFiles = 3
#
# Set the number of seconds for the high availability (HA) minimum
# timeout. Communication is considered lost on a managed node
# once the timeout period has elapsed.
#
# By default, communication is not considered lost until 10 allocation
# intervals have elapsed without communication. The default value of the
# property (60) is used only when the allocation interval is less than 6
# seconds.
#
com.hp.gwlm.node.HA.minimumTimeout = 60
#
# Enable/disable use of Instant Capacity (iCAP) to simulate movement of
# cores across nPartitions. To use iCAP, you must enable this property on
# each managed nPartition where you want to take advantage of iCAP. Also,
# each nPartition must meet the requirements outlined in the online help
# topic "Getting the most out of gWLM" as well as in the section "USING
# nPars AS COMPARTMENTS IN AN SRD" in the gwlmxml(4) man page on HP-UX or
# the gwlmxml(5) man page on Linux.
#
com.hp.gwlm.platform.icap.manageWithIcap = on
#
# Set the minimum number of Temporary Instant Capacity (TiCAP) minutes
# that must be available for TiCAP activation. gWLM will stop using
# TiCAP when the available balance goes below this threshold. The
# same value should be set on all agents managing the SRD. To use
# TiCAP, it must be available on the complex and enabled at the policy
# level or the SRD level.
#
com.hp.gwlm.node.ticap.minimumBalance = 30
Ports de communication
gWLM utilise les ports de communication suivants :
Nœuds gérés : 9617
CMS : 9618
Si vous devez changer ces ports, ajoutez les lignes suivantes :
com.hp.gwlm.cms.port =portX
com.hp.gwlm.node.port =portY
aux deux fichiers de propriétés :
•
gwlmcms.properties
Sous HP-UX, ce fichier se trouve dans /etc/opt/gwlm/conf/. Sous Windows, il se trouve
dans C:\Program Files\HP\Virtual Server Environment\conf\. (Le chemin
Windows donné est le chemin par défaut. Cependant, un chemin différent a pu être choisi
lors de l'installation.)
•
/etc/opt/gwlm/conf/gwlmagent.properties
Les valeurs portX et portY ne peuvent être identiques.
La propriété com.hp.gwlm.cms.port doit avoir la même valeur portX dans tous les fichiers de
propriétés sur tous les nœuds gérés et sur le CMS. De même, la propriété com.hp.gwlm.node.port
doit avoir la même valeur portY dans tous les fichiers de propriétés sur tous les nœuds gérés et
sur le CMS.
40
Autres tâches de configuration et d'administration