Robertshaw RS6320C - Manuel (Page 10)

10
Pop-Up Wizard
The Wizard routine will display factory default settings. Each setting will
display for ten seconds. Use the or buttons to change the setting.
Settings that are not changed will operate with the values that are
displayed. To fast forward through the Wizard, press Edit Schedule. The
Wizard can be exited by pressing Start/Stop Schedule. This will save the
settings and place the thermostat into operation.
Use this chart to write down the desired settings before applying power.
Settings may vary by model.
Displayed Details Default Change To
SCAL choose °F or °C °F _______
CLOC choose 12 or 24 hour 12 _______
LITE y = always on, n = off y _______
DIFF differential, set between 0.5 to 3.0 °F
or 0.5 to 1.5 °C 1 °F _______
DIF2 2nd stage differential,
added to first stage differential 2 °F _______
DLY2 2nd stage delay, in minutes 20 _______
DLY3 3rd stage delay, in minutes 20 _______
AUTO auto changeover enable y _______
DEDB auto changeover deadband
in degrees 3 °F _______
HI heat setting limit in degrees 90 °F _______
LO cool setting limit in degrees 45 °F _______
VAC HEAT vacation heat setpoint in degrees 62 °F _______
VAC COOL vacation cool setpoint in degrees 85 °F _______
CHECK check filter timer in hours n or OFF _______
CYCL compressor short cycle delay in minutes 5 _______
CAL calibration offset in degrees 0 _______
After the Wizard has configured the thermostat, the settings can be
edited by pressing and simultaneously. This will allow you to
change settings.
Factory settings that have not been changed will use the default settings
for operation.