Display(s), Number codes, Start, add a minute – Whirlpool GSC309 Manuel d'utilisation

Page 6: Upper oven cancel, Clock, Tones

Advertising
background image

6

Display(s)

When power is first supplied to the appliance, everything on the
display(s) will light up for 5 seconds. Then, “PF id = 27” or
“PF id = 30” will appear. Touch LOWER OVEN OFF/CANCEL or
UPPER OVEN OFF/CANCEL to clear display(s).

Any other time “PF id = 27” or “PF id = 30” appears, a power
failure occurred. Touch LOWER OVEN OFF/CANCEL or UPPER
OVEN OFF/CANCEL and reset the clock if needed.

Lower Oven Display

When the lower oven is in use, this display shows the lower oven
temperature, heat source(s) and start time.

During lower oven Timed Cooking, this display also shows a
vertical bar and minute time countdown and the stop time (if
entered).

If “Err” appears on the display, an invalid pad was touched.
Touch LOWER OVEN OFF/CANCEL and retry the entry.

When the lower oven is not in use, this display is blank.

Upper Oven Display

When the upper oven is in use, this display shows the upper oven
heat source(s), cooking power, quantities, weights and/or help
prompts.

If “RETRY” flashes on the display for 1 second, an invalid pad
was touched. Retry the entry.

When the upper oven is not in use, this display shows the time of
day or Timer countdown.

Number Codes

The oven is preset with shortcut number codes for High Speed
and Microwave Cooking. A number code includes one or more of
the following; cooking power, cook time and food quantity or
weight. See the code charts in the “High Speed Cooking,”
“Custom Reheating,” “Custom Defrosting” and “Popcorn”
sections for additional information.

Start, Add a Minute

The START pad controls 2 separate functions: Start and Add a
Minute.

Starting

The START pad begins any upper or single oven function except
the Timer. If not touched within 5 seconds after pressing a pad,
“START?” will appear on the display as a reminder. If not touched
within 5 minutes after pressing a pad, the display will return to the
time of day mode and the programmed function will be canceled.
If cooking is interrupted, touching START will resume the preset
cycle.

Adding Minutes

During High Speed Cooking, Crisping and Broiling, touching ADD
A MINUTE (START) while the oven is operating will add cook time
in 1-minute increments.

During Microwave Cooking, touching ADD A MINUTE while the
oven is operating, or at the end of a cycle, will add cook time in
1-minute increments.

During Convection Cooking, touching ADD A MINUTE will not
add minutes.

Upper Oven Cancel

The UPPER OVEN OFF/CANCEL pad stops any upper oven
function except for the Clock, Timer and Control Lock.

The oven will also turn off when the door is opened. When the
door is opened, the element(s) and fan will turn off, but the oven
light will remain on. Close the door and touch START to resume
the cycle.

Clock

This is a 12-hour clock and does not show a.m. or p.m.

To Set:

Before setting, make sure the ovens, Timer and Timed Cooking
are off.

1. Touch CLOCK.
2. Touch the number pads to set the time of day.
3. Touch CLOCK.
To remove the time of day from the display: Touch and hold
CLOCK 5 seconds.

To return the time of day to the display: Touch CLOCK. The
time should not have to be reset.

Tones

Tones are audible signals, indicating the following:

One tone

Valid pad touch

Oven is preheated

Function has been entered

Three tones

Invalid pad touch

Four tones

End of cycle

Reminder, repeating each minute after the end-of-cycle tones

All Tones (combination oven models only)

All of the above tones are preset on, but can be turned off.

To Turn Off/On: Touch and hold TIMER OFF for 5 seconds.
A tone will sound, and “Snd oFF” will appear on the lower oven
display for 3 seconds. Repeat to change back to “Snd on.”

Tone Volume

The volume is preset at high, but can be changed to low.

To Change: Touch and hold the number pad “7” for 5 seconds.
A tone will sound, and “Snd Lo” will appear on the lower oven
display for 3 seconds. Repeat to change back to “Snd HI.”

Reminder tones

The Timer and Timed Cooking reminder tones are preset on,
but can be turned off. Reminder tones do not include end-of-
cycle tones. On combination oven models, if “All Tones” have
been turned off, the reminder tones cannot be independently
turned on.

Timer

To Turn Tones Off/On: Touch and hold TIMER SET until a tone
sounds. Repeat to turn back on.

Timed Cooking

To Turn Tones Off/On: Touch and hold COOK TIME until a tone
sounds and the lower oven display returns to inactive mode
(blank). Repeat to turn back on.

Advertising