Onkyo TX-SR707 - Manuel (Page 68)

68
Recording
This section explains how to record the selected input
source to a component with recording capability, and
how to record audio and video from different sources.
Notes:
• The surround sound and DSP listening modes cannot
be recorded.
• Copy-protected DVDs cannot be recorded.
• Sources connected to a digital input cannot be
recorded. Only analog inputs can be recorded.
• DTS signals will be recorded as noise, so don’t
attempt analog recording of DTS CDs or LDs.
• While the listening mode is set to Pure Audio, no
image is provided because the power is turned off for
the video circuit. If you want to make recordings,
select other listening mode.
AV Recording
Audio sources can be recorded to a recorder (e.g., cas-
sette deck, CDR, MD) connected to the TV/TAPE OUT
jack. Video sources can be recorded to a video recorder
(e.g., VCR, DVD recorder) connected to the VCR/DVR
OUT jack. See pages 26 to 39 for hookup information.
Recording Separate AV Sources
Here you can record audio and video from completely
separate sources, allowing you to overdub audio onto
your video recordings. This function takes advantage of
the fact that when an audio-only input source (i.e., TV/
TAPE, TUNER, CD or PHONO) is selected, the video
input source remains unchanged.
In the following example, audio from the CD player con-
nected to the CD IN, and video from the camcorder con-
nected to the AUX INPUT VIDEO jack are recorded by
the VCR connected to the VCR/DVR OUT jacks.
1 Use the input selector buttons to
select the source that you want
to record.
You can watch the source while record-
ing. The AV receiver’s MASTER VOL-
UME control has no effect on
recording.
2 On your recorder, start record-
ing.
3 On the source component, start
playback.
If you select another input source dur-
ing recording, that input source will be
recorded.
1 Prepare the camcorder and CD player for
playback.
2 Prepare the VCR for recording.
3 Press the [AUX] input selector button.
4 Press the [CD] input selector button.
This selects the CD player as the audio source, but
leaves the camcorder as the video source.
5 Start recording on the VCR and start play-
back on the camcorder and CD player.
The video from the camcorder and the audio from
the CD player are recorded by the VCR.
Camcorder
VCR CD player
video signal
audio signal
TX-SR707_En.book Page 68 Tuesday, July 28, 2009 1:03 PM