Onkyo TX-SR707 - Manuel (Page 43)

43
First Time Setup
—Continued
You can specify the output resolution for the HDMI
OUT and COMPONENT VIDEO MONITOR OUT and
have the AV receiver upconvert the picture resolution as
necessary to match the resolution supported by your TV.
Note:
This procedure can also be performed on the AV receiver
by using its [SETUP] button, arrow buttons, and
[ENTER] button.
Monitor Out Setup
1 Press the [RECEIVER] button,
followed by the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make
sure the appropriate external input is
selected on your TV.
2 Use the Up and Down [ ]/[ ] but-
tons to select “1. Input/Output
Assign”, and then press
[ENTER].
The “Input/Output Assign” menu
appears.
3 Use the Up and Down [ ]/[ ] but-
tons to select “1. Monitor Out”,
and then press [ENTER].
The “Monitor Out” menu appears.
SETUP
RECEIVER
ENTER
1. Input/Output Assign
1. Monitor Out
2. HDMI Input
3. Component Video Input
4. Digital Audio Input
Resolution Through
1–1. Monitor Out
4 Use the Left and Right [ ]/[ ]
buttons to select:
Through:
Select this to pass video through the
AV receiver at the same resolution
and with no conversion.
Auto:
Select this to have the AV receiver
automatically convert video at reso-
lutions not supported by your TV.
480p (480p/576p):
Select this for 480p or 576p output
and video conversion as necessary.
720p:
Select this for 720p output and
video conversion as necessary.
1080i:
Select this for 1080i output and
video conversion as necessary.
1080p:
Select this for 1080p output and
video conversion as necessary.
Tip:
The “Resolution” setting can also be set
using the [VIDEO] button on the
remote controller.
5 Press the [SETUP] button.
The setup menu closes.
TX-SR707_En.book Page 43 Tuesday, July 28, 2009 1:03 PM