First time setup —continued – Onkyo TX-SR707 Manuel d'utilisation

Page 52

Advertising
background image

52

First Time Setup

—Continued

• Make the room as quiet as possible.

Background noise can disrupt the
room measurements. Close
windows, silence cell phones,
televisions, radios, air conditioners,
fluorescent lights, home appliances,
light dimmers, or other devices.

• Cell phones should be turned off or

placed away from all audio
electronics during the measurement
process as Radio Frequency
Interference (RFI) may cause
measurement disruptions (even if the
cell phone is not in use).

4

Press [ENTER].
The room correction and speaker setup
starts.

Test tones are played through each
speaker as Audyssey MultEQ

®

Room

Correction and Speaker Setup runs.
This process takes a few minutes.
Please refrain from talking during
measurements and do not stand
between speakers and the microphone.

5

The following screen appears.

Place the setup microphone at
the next position (page 50), and
then press [ENTER].
Audyssey MultEQ performs more
measurements. This takes a few
minutes.

MultEQ: Auto Setup

Do not unplug setup microphone.

Please keep quiet.

Now measuring. . .

MultEQ: Auto Setup

Next

Please place setup microphone at 2nd position at

ear height.

MultEQ: Auto Setup

Do not unplug setup microphone.

Please keep quiet.

Now measuring. . .

6

When prompted, place the setup
microphone at the next position,
and repeat step 5.

7

After the 3rd to the 5th measure-
ment, the following screen
appears.

Use the Up and Down [ ]/[ ] but-
tons to select an option, and then
press [ENTER].

Next:

Select “Next” to begin measuring
the next measurement position.
After the 6th measurement has been
taken, the procedure automatically
proceeds to step 8.

Finish(Calculate):

Select this if you don’t want to
measure any more listening posi-
tions and are ready to calculate the
results, then go to step 8.

8

When the measurements are
complete, the following screen
appears.

MultEQ: Auto Setup

Next
Finish(Calculate)

Please select [Next], when measuring next position,

and select [Finish], when ending.

MultEQ: Auto Setup

Calculating...

TX-SR707_En.book Page 52 Tuesday, July 28, 2009 1:03 PM

Advertising