Onkyo TX-SR707 - Manuel (Page 106)

106
Zone 2
—Continued
Notes:
• Only analog input sources are output by the ZONE 2
LINE OUT and ZONE 2 L/R speaker terminals. Dig-
ital input sources are not output. If no sound is heard
when an input source is selected, check if it’s con-
nected to an analog input.
• You cannot select different AM or FM radio stations
for your main room and Zone 2. The same AM/FM
radio station will be heard in each room. For example,
if you have an FM station for the main room, that sta-
tion will also be used in Zone 2.
• When you connect Zone 2 speakers directly to the AV
receiver, listening modes that require surround back
speakers or front high speakers or front wide speakers
(6.1/7.1), such as Dolby Digital EX, DTS-ES, THX
Select2 Cinema, Dolby Pro Logic IIz height, and
Audyssey Dynamic Surround Expansion™ are
unavailable.
• When the input selector of Zone 2 is selected, power
consumption on standby mode slightly increases.
• While Zone 2 is on, functions will not work.
Adjusting the Volume for Zone 2
Note:
You can adjust the volume only when Powered Zone 2 is
being used.
Muting Zones
Note:
Zones can also be unmuted by adjusting the volume.
Remote
controller
On the remote controller, press
the [ZONE2] button, and then use
the VOL [ ]/[ ] button.
AV receiver On the AV receiver, press the
[ZONE 2] button (the ZONE 2
indicator and Zone 2 selector on
the display flashes) and use the
[–]/[+] buttons within 8 seconds.
Remote
controller
On the remote controller, press
the [ZONE2] button, and then
press the [MUTING] button.
To unmute a zone, on the remote
controller, press the [ZONE2]
button, and then press the
[MUTING] button again.
TX-SR707_En.book Page 106 Tuesday, July 28, 2009 1:03 PM