Onkyo TX-SR707 - Manuel (Page 53)

53
First Time Setup
—Continued
Notes:
• When the room correction and speaker setup is
complete, the “Equalizer Settings” (page 82) will be
set to “Audyssey” and the “Dynamic EQ” (page 86)
will be set to “On”.
• You can cancel the Room Correction and Speaker
Setup at any point in this procedure simply by
disconnecting the setup microphone.
Error Messages
While the room correction and speaker setup is in
progress, one of the following error messages may
appear:
❏ Ambient noise is too high.
This message appears if the background noise is too
loud and the measurements cannot be performed
properly.
Remove the source of the noise and try again.
Retry: Return to the measured point immediately
before and start set up again.
Cancel: Cancel the room correction and speaker setup.
❏ Speaker Detect Error
This message appears if a speaker is not detected. “Yes”
means that a speaker was detected. “No” means that no
speaker was detected.
The front speaker has not been detected.
One of the front speakers has not been detected.
9 When the calculations are com-
plete, the following screen
appears.
Use the Up and Down [ ]/[ ] but-
tons to select an option, and then
press [ENTER].
The options are:
Save:
Save the calculated settings and exit
the room correction and speaker
setup.
Cancel:
Cancel the room correction and
speaker setup.
Note:
You can view the calculated settings for
the speaker configuration, speaker dis-
tances, and speaker levels by using the
Left and Right [
]/[ ] buttons.
10 If you selected “Save”, the results are
saved, and the following screen
appears.
11 Disconnect the speaker setup
microphone.
Subwoofer No
Front Full
Band
Center 40Hz
Surround 120Hz
Front Wide
Full Band
Front High Full Band
Surr Back 150Hz
Surr Back Ch 2ch
-- Review SP Configuration --
MultEQ: Auto Setup
Save
Cancel
MultEQ: Auto Setup
Saving...
MultEQ: Auto Setup
Please, unplug setup microphone.
MultEQ: Auto Setup
Retry
Cancel
Ambient noise is too high.
FL : No
SL : ---
FWL :
---
FHL : ---
SBL : ---
C : ---
FR : ---
SR : ---
FWR :
---
FHR : ---
SBR :
---
SW : ---
MultEQ: Auto Setup
Retry
Cancel
Speaker Detect Error
MultEQ: Auto Setup
Retry
Cancel
Speaker Detect Error
FL : Yes
SL : ---
FWL : Yes
FHL : Yes
SBL : ---
C :
Yes
FR : No
SR : ---
FWR : Yes
FHR : Yes
SBR :
---
SW : ---
TX-SR707_En.book Page 53 Tuesday, July 28, 2009 1:03 PM