Napoleon Fireplaces GDI-30P - Manuel (Page 19)

19
W415-0384 / C / 07.15.08
16) This should appear in the framing sections following the statement “ It is not necessary to install a hearth
extension with this fi replace system ”. The next line should be:
When roughing in the fi replace, raise the fi replace to accommodate for the thickness of the fi nished fl oor materials, i.e. tile,
carpeting, hard wood, which if not planned for will interfere with the opening of the lower access door and the installation of
many decorative fl ashing accessories.
17) Standards:
Note from Cliff stating that STANDARD for HEATERS:
Z21.88 and CSA 2.33
were just updated to
CSA 2.33-2002 and ANSI Z21-88-2002
CERTIFIED UNDER CANADIAN AND AMERICAN NATIONAL STANDARDS , CSA 2.33, ANSI Z21.88 FOR VENTED GAS FIREPLACE HEATERS
Rating plates keep date but other literature does not.
STANDARD for DECORATIVE FIREPLACES :
Z21.50-2000 · CSA 2.22-2000
updated to
Z21.50a-2001· CSA 2.22a-2001
CERTIFIED UNDER CANADIAN AND AMERICAN NATIONAL STANDARDS, CSA 2.22, AND ANSI Z21.50 RESPECTIVELY FOR VENTED GAS FIREPLACES.
18) Change NAPOLEON LOGO under REPLACEMENT PARTS
FROM:
W385-0033
TO:
W385-0245
For CONTINENTAL USE
W385-0131
19) In all DIRECT VENT manuals, update venting graphs to look like GD36 W415-0210.
20) If already added, update Massachusetts statement (see 2) to:
Installation practices vary from region to region and it is important to know the specifi cs that apply to your area,
for example: in Massachusetts State:
• The fi replace damper must be removed or welded in the open position prior to installation of a fi replace insert or gas log.
• The appliance off valve must be a “T” handle gas cock.
• The fl exible connector must not be longer than 36 inches.
• The appliance is not approved for installation in a bedroom or bathroom unless the unit is a direct vent
sealed combustion product.
• WARNING: This product must be installed by a licensed plumber or gas fi tter when installed within the commonwealth of
Massachusetts.
21) On the front page replace:
CERTIFIED FOR CANADA AND UNITED STATES USING ANSI / AGA / CGA METHODS
with:
CERTIFIED FOR CANADA AND UNITED STATES USING ANSI / CSA METHODS
22) Add Logo Placement Section from Leafl et into the manuals.
23) In ALL Vent Free manuals, in the VENTURI ADJUSTMENT section, after “...can lead to carboning *”
add:
WARNING: Carbon can be distributed in surrounding living area if the air shutter is improperly adjusted.
24) In all Direct Vent manuals, under USING RIGID VENT COMPONENTS, in the fi rst paragraph,
after “Use Wolf Steel vent spacers..”
remove
“or equivalent”.
25) In all zero clearance manuals, under MANTLE CLEARANCE, add top of combustible enclosure graphic.
See W415-0341 B&GD33/34 manual.