Polk/momo series limited warranty – Polk Audio C500.1 Manuel d'utilisation

Page 22

Advertising
background image

22

P O L K / M O M O : C H A M P I O N S H I P P E R F O R M A N C E

C500.1 Specifications

Power Output: RMS Continuous Power
(at 14.4V at the input terminals, 20Hz - 200Hz)
Per Channel into 4 Ohms (1% THD+N) 350W
Per Channel into 2 Ohms (1% THD+N) 500W
Total Dynamic Power (at 50Hz) 875W
Frequency Response (-3dB Points) <15 Hz to 200Hz
Signal-to-Noise (Referenced to rated power >100dBA
Input Sensitivity 200mV to 8.0V
Remote Gain Control 0 to -30dB
Input Impedance > 10k Ohms
Speaker Impedance > 2 Ohms
Power Requirement 10V to 16V DC Negative Ground

Low-pass Filter
Slope

12 or 24dB/Octave

Frequency (-3dB Points) 30Hz to 200Hz
Subsonic Filter 24dB/Octave at 15Hz

Bass Boost
Center Frequency 30Hz to 160Hz
Bandwidth 1/3 Octave
Gain

0 to 18dB

Pre-EQ
Center Frequency 40Hz
Bandwidth 1/3 Octave
Gain

+9dB

Dimensions (L x W x H)
Inches

11 x 9.75 x 2.5

Centimeters 27.94 x 24.8 x 6.35

Fiche technique du CC500.1

Puissance de sortie: Puissance RMS continue
(14,4V à l’entrée, 20Hz - 20kHz)

Par canal, 4 Ohms (1% DHT+B) 350W

Par canal, 2 Ohms (1% DHT+B) 500W

Puissance dynamique totale 875W

Réponse en fréquences (-3dB) <15Hz à 200Hz

Rapport signal-bruit (ref. puissance nominale) >100dBA

Sensibilité d’entrée 200mV to 8,0V

Contrôle de gain à distance 0 à -30dB

Impédance d’entrée >10k Ohms

Impédance sortie haut-parleur >2 Ohms

Puissance d’alimentation requise

10V à 16V DC

masse négative

Filtres de séparation

Pente

12 ou 24dB/octave

Fréquence (-3db) 30Hz à 200Hz

Bande passante 1/3 d’octave

Gain

0 à 18dB

Pre-EQ

Pente

40Hz

Bande passante 1/3 d’octave

Gain

+9dB

Dimensions (P x L x H)

Pouces 11 x 9,75 x 2,5

Centimètres 27,94 x 24,8 x 6,35

Polk Audio, Inc., warrants to the original retail purchaser only. This
warranty will terminate automatically prior to its stated expiration if
the original retail purchaser sells or transfers the Product to any
other party.

Polk Audio, Inc., warrants, to the original retail purchaser only, that
the LOUDSPEAKER(S), PASSIVE CROSSOVER COMPONENT(S) and
ENCLOSURE on this Polk Audio Loudspeaker Product will be free
from defects in material and workmanship for a period of one (1)
year from the date of original retail purchase from a Polk Audio
Authorized Dealer.

Furthermore, Polk Audio, Inc., warrants, to the original retail pur-
chaser only, that any AMPLIFIER OR OTHER ELECTRONIC COMPO-
NENT will be free from defects in material and workmanship for a
period of one (1) year (extended to two years when professionally
installed) from the date of original retail purchase from a Polk Audio
Authorized Dealer.

To allow Polk Audio to offer the best possible warranty service, please
register your new product online at: www.polkaudio.com/registration
or call Polk customer service 800-377-7655 in the USA and Canada (out-
side the USA: 410-358-3600) within ten (10) days of the date of original
purchase. Be sure to keep your original purchase receipt.

Defective Products must be shipped, together with proof of pur-
chase, prepaid insured to the Polk Audio Authorized Dealer from

whom you purchased the Product, or to the Factory at 2550
Britannia Boulevard, Suite A, San Diego, California 92154. Products
must be shipped in the original shipping container or its equivalent;
in any case the risk of loss or damage in transit is to be borne by
you. If upon examination at the Factory or Polk Audio Authorized
Dealer it is determined that the unit was defective in materials or
workmanship at any time during this Warranty period,
Polk Audio or the Polk Audio Authorized Dealer will, at
its option, repair or replace this Product at no additional charge,
except as set forth below. All replaced parts and Products become
the property of Polk Audio. Products replaced or repaired under this
warranty will be returned
to you, within a reasonable time, freight prepaid.

This warranty does not include service or parts to repair damage
caused by accident, disaster, misuse, abuse,
negligence, inadequate packing or shipping procedures, commercial
use, voltage inputs in excess of the rated
maximum of the unit, cosmetic appearance of cabinetry
not directly attributable to defect in materials or workmanship, or
service, repair, or modification of the Product
which has not been authorized or approved by Polk Audio. This war-
ranty shall terminate if the Serial number on the Product has been
removed, tampered with or defaced.

Polk/MOMO Series Limited Warranty

Advertising