Sony DSR-20/20P - Manuel (Page 29)

Chapter 2 Playback and Recording
Chapter 2 Recording and Playback
29 EN
This section describes the necessary connections, settings and operations
to perform recording on this unit. The same settings and operations apply
whether you are using the unit as part of an editing system, for dubbing, or
as a stand-alone recorder.
Connections for Recording
To digital video equipment with DV connector
The video and audio signals are sent with hardly any degradation, enabling
high-quality editing. The signal flow is automatically detected so you need
not make separate connections for input and output.
Notes
• Audio signals are not output during playing at various speeds.
• With the DV connection, the sound is recorded in the same audio
recording mode as that of the source tape. To record in a different audio
recording mode from the source tape, use the LINE connection instead.
• With the DV connection, tape information (recording date, camcorder
data, etc.) recorded on the source tape is transmitted from the other VCR
(player). As a result, when you play back a recorded tape and press
DATA CODE, the same tape information recorded on the source tape is
displayed on the monitor screen. However, contents of the cassette
memory are not transmitted. In addition, the time code is newly recorded
on the tape on this VCR, except when copying a tape in Duplicate mode.
• As for the LANC connection, see “Notes for LANC connection” on the
next page.
LANC DV
IN/OUT
Recording
Player Recorder
Other VCR
This VCR
Monitor
DV cable (not supplied)
LANC cable (not supplied)
ç : Signal flow
to the DV
jack to the LANC
jack