Sony TA-VE810G - Manuel (Page 8)

8 GB
Hooking Up the System
Yellow
White (L)
Red (R)
Yellow
White (L)
Red (R)
TV-VCR Hookups
You must connect a TV to control the amplifier using
the on-screen display. Also, to enjoy the Dolby Pro
Logic Surround encoded videos and TV programmes,
you need to connect TV and VCRs together with the
centre and rear speakers.
If your components are Sony products, connect them to
the jacks as shown in the table on page 15, this makes
IR registration is unnecessary.
What cables will I need?
• Audio/video cable (not supplied)
• SCART cable (not supplied)
Make sure to match the colour of the plugs and the
jacks: Yellow (video) to Yellow; White (left, audio) to
White; and Red (right, audio) to Red.
Ç : signal flow
5.1 INPUT
d SATL b VIDEO 1, 2 a MONITOR
e VIDEO 3 INPUT
(on the front panel)
c LD/DVD
Speaker placement
For optimum surround sound effect, place your
speakers as shown below.
z
You can connect an active woofer
You can reinforce the bass sound by connecting an
optional active woofer to the WOOFER AUDIO OUT
terminal.
z
You can connect wireless rear speakers
When using an optional Sony wireless rear speaker
system, connect the transmitter to the WIRELESS REAR
SPEAKER connector.
Note
Do not connect any other components to the WIRELESS
REAR SPEAKER connector.
Selecting the speaker system
You can connect one set or two sets of speakers. Set the
SPEAKERS selector on the front panel according to
your speaker system.
To drive Set SPEAKERS selector to
Speaker system A A
(connected to the FRONT
SPEAKERS A terminals)
Speaker system B B
(connected to the FRONT
SPEAKERS B terminals)
Both speaker systems A and B A+B*
(parallel connection)
* Connect speakers with nominal impedance of 8 ohms, or
higher, to the A and B terminals.
Active woofer
Front speaker
Rear speaker
60 - 90 cm
(2 - 3 feet)
AUDIO
OUT
WDOFER INPUT
Amplifier