Sony TA-VE810G - Manuel (Page 44)

44 GB
Additional Information
Troubleshooting
If you run into any problems using this amplifier, use
the following list.
First, check that the power cord is connected firmly.
Should any problem persist, consult your nearest Sony
dealer.
Power
The TV turns off when you turn on the amplifier with the
remote.
/ Make sure that the TV is off when you turn
on the amplifier with the remote.
The component turns off when you select a component
with the remote.
/ The component was turned on by another
remote. The component needs to be turned
on by the amplifier's remote or manually
(after selection).
Some components do not turn off when you press ALL
OFF.
/ The component was turned on by another
remote. Turn off the component manually.
On-screen control
The on-screen display does not appear.
/ Set your TV to the appropriate input mode.
/ Place your TV away from the audio
components.
/ Select the appropriate component on the
amplifier.
The on-screen display does not respond or disappears
while you are using the remote.
/ Make sure the remote is not too far from the
IR sensor.
The on-screen display becomes distorted when you select
a component with the remote.
/ There may be distortion in the video signal,
but this is not a malfunction, continue as is.
You have difficulty operating the unit because the on-
screen display is distorted.
/ If you connect two or more VCRs to the
amplifier, make sure to use a distributor
when connecting the TV aerial to the VCRs to
preserve video signal quality.
/ Clean the head of the VCR.
/ Do not select channels where there is no
broadcast. Set your VCR (etc.) to skip
channels where there is no broadcast.
The remote does not function.
/ Replace weak batteries in the remote with
new ones.
/ Remove any obstacles in the path of the
remote and the IR sensor.
/ The infrared (IR) signals transmitted from the
IR emitter may not be reaching the IR sensor
on the respective component. In such a case,
connect the IR repeater to IR OUT jack on the
rear of the amplifier (see page 6).
Sound
No sound or only a very low-level sound is heard.
/ Check that the speakers and components are
connected securely.
/ Make sure you select the correct component
on the amplifier.
/ Make sure you set the SPEAKERS selector
correctly (see page 8).
/ Click the icon if “MUTING” is displayed.
/ The protective device on the amplifier has
been activated because of a short circuit.
(“PROTECTOR” flashes.) Turn off the
amplifier, eliminate the short-circuit problem
and turn on the power again.
The left and right sounds are unbalanced or reversed.
/ Check that the speakers and components are
connected correctly and securely.
/ Adjust the BALANCE control on the front
panel.