Sony CDP-CE575 - Manuel (Page 7)

Getting Started
7 US
Making digital hookups
If you have a digital component such as a
digital amplifier, D/A converter, DAT, or MD,
connect the component via the DIGITAL OUT
(OPTICAL) connector using the optical cable
(not supplied). Take off the cap and plug in the
optical cable.
Note that you cannot use the following
functions when making this connection:
• Fading In or Out (see page 14)
• Adjusting the output level using the
ANALOG OUT LEVEL +/– buttons on the
remote
Note
When you connect via the DIGITAL OUT
(OPTICAL) connector, noise may occur when you
play CD software other than music, such as a CD-
ROM.
POC-15
Optical cable (not supplied)
Digital component CD player
DIGITAL
OUT
OPTICAL
DIGITAL
INPUT
OPTICAL
When using another Sony CD player
in conjunction with this player
You can set the supplied remote to be effective
on this player only.
• If the other player’s command mode can be set:
Set the CD1/2/3 switch of this player’s remote to
CD1 (factory setting), and set the other player’s
remote to CD2 or CD3.
• If the other player’s command mode cannot be set:
Set the CD1/2/3 switch of this player’s remote to
CD2 or CD3.
When you change the command mode of the
remote, you have to set the command mode of each
player. For details, see “Changing the command
mode of the player” on page 8.
Transporting the player
Before transporting the player, follow the
procedure below to return the internal
mechanisms back to their original position.
1
Remove all the discs from the disc tray.
2
Press A OPEN/CLOSE to close the
disc tray.
“–NO DISC–” appears in the display.
3
Wait for 10 seconds, then press
POWER to turn off the player.