Sony 3-097-196-14(1) - Manuel (Page 68)

CMT-DH5BT.GB.3-097-196-11(1)
 GB
4
Press and hold BLUETOOTH
OPR
 on the unit for about 7
seconds until the BLUETOOTH
indicator
 flashes.
Sound output from the speakers is
stopped.
5
Enter the passcode.
Follow the same procedure as in
step 4 of “Pairing this system with a
Bluetooth device” (page 64).
Once pairing is completed and the
connection is established, the system
display changes as follows:
“Connect”  Name of the Bluetooth
device
To cancel passcode entry partway
Press   .
Notes
 “Passcode” may be called “Passkey,” “PIN
code,” “PIN number” or “Password,” etc.
depending on the device.
 This system only supports numerical
passcodes up to 4 digits.
 The pairing standby status of the system is
cancelled after about 30 seconds. If pairing is
not successful, redo the procedure from step
1.
 While connected to a Bluetooth device, this
system cannot be detected and a connection
cannot be established from another
Bluetooth device.
 Pairing may not be possible if other
Bluetooth devices are present around the
system. In this case, turn off the other
Bluetooth devices.
To erase all the pairing registration
information
1
Press FUNCTION +/  repeatedly
to select “BLUETOOTH” (or press
BLUETOOTH   on the unit).
When the system is connected with a
Bluetooth device (when the Bluetooth
device name or other information
appears in the system display), press
and hold BLUETOOTH OPR  on
the unit for about 2 seconds to put the
system in Bluetooth standby mode.
2
Press CLEAR  .
“Delete?” appears.
3
Press ENTER  .
“Complete!” appears and all the
pairing information is erased.
Note
To connect with Bluetooth headphones after
performing this operation, you must enter the
passcode again.