John Deere AC2-80ES - Manuel (Page 14)

4 Stationary Electric Air Compressor Manual
OPERATING INSTRUCTIONS
START-UP:
. Read safety warnings before performing operation.
. Move the Motor/Pressure Switch to the "AUTO" position.
3. If you notice any unusual noise or vibration, stop the air compressor and refer
to "Troubleshooting".
SHUTDOWN:
. To stop the air compressor, move the Motor/Pressure Switch to the "OFF"
position.
. Drain air from the air tanks by releasing air with an attached air tool or by
pulling on the Safety Relief Valve.
3. Once the Air Tank Pressure Gauge registers under 0 pounds, open the Air
Tank Drain Valve under the air tank to drain any moisture.
4. Allow the air compressor to cool down, then wipe clean.
MAINTENANCE INSTRUCTIONS
Read the instruction manual before performing maintenance. The following
procedures must be performed when stopping the air compressor for maintenance
or service.
. Turn off air compressor.
. Open all drains after the tank gauge registers under 0 PSI..
3. Wait for the air compressor to cool before starting service.
WARNING
RISK OF BODILY INJURY!
Never assume the air
compressor is safe to work
on just because it is not
operating. It could restart at
any time!
*THE PUMP OIL MUST BE CHANGED AFTER THE FIRST 00 HOURS OF OPERATION AND EVERY 000
HOURS OR 3 MONTHS, WHICHEVER COMES FIRST.
EVERY TWO YEARS, AN AUTHORIzED SERVICE TECHNICIAN SHOULD CHECK THE CHECK VALVE, INTAKE
VALVES AND DELIVERY VALVES.
AC Ele. Maintenance Chart
MAINTENANCE CHART
PROCEDURE DAILY WEEKLY MONTHLY 1000 HOURS
Check pump oil level X
Oil leak inspection X
Drain condensation in air tank (s) X
Inspect guards/covers X
Check for unusual noise/vibration X
Check for air leaks X
Clean exterior of compressor X
Inspect air fi lter X
Inspect belt X
Check safety relief valve X
Change pump oil * X
Replace air fi lter X