Maytag W10296136A-SP - Manuel (Page 13)

13
8. Remove door strike (E) from cabinet. Use a small, flat-blade
screwdriver to gently remove 4 hinge hole plugs (F) on left
side of cabinet. Insert plugs into hinge holes on right side
of cabinet.
9. Insert screws into bottom holes on left side of cabinet.
Tighten screws halfway. Position door so large end of door
hinge slot is over screws. Slide door up so screws are in
bottom of slots. Tighten screws. Insert and tighten top
screws in hinges.
10. Remove door strike plug (B). Insert the door strike you
removed in Step 8 into hole and secure with screw. Insert
door strike plug into original door strike hole and secure
with screw.
11. Close door and check that door strike aligns with door
catch (C). If it is needed, slide door catch left or right within
slot to adjust alignment.
27" Wide models
Reversible Side-Swing Door
Appearance may vary
B
D
C
A
1. Place towel (A) on top of dryer to avoid damaging the
surface.
2. Open dryer door. Remove bottom screws from cabinet
side of hinges (B). Loosen (do not remove) top screws from
cabinet side of hinges.
3. Lift door until top screws in cabinet are in large part of hinge
slot. Pull door forward off screws. Set door (handle side up)
on top of dryer. Remove top screws from cabinet.
4. Remove screws attaching hinges to door.
5. Remove screws at top, bottom, and side of door (4 screws).
Holding door over towel on dryer, grasp sides of outer door
and gently lift to separate it from inner door. Do not pry apart
with putty knife. Do not pull on door seal or plastic door
catches.
6. Be certain to keep cardboard spacer centered between
doors. Reattach outer door panel to inner door panel so
handle is on the side where hinges were just removed.
7. Attach door hinges to dryer door so that the larger hole is
at the bottom of the hinge.
8. Remove the 4 screws that attach 2 plugs (D) on the left side.
Attach plugs to right side using the same 4 screws.
9. Insert screws into bottom holes on left side of cabinet.
Tighten screws halfway. Position door so large end of door
hinge slot is over screws. Slide door up so screws are in
bottom of slots. Tighten screws. Insert and tighten top
screws in hinges.
10. Close door and check that door strike aligns with door
catch (C). If it is needed, slide door catch left or right
within slot to adjust alignment.