Maytag W10296136A-SP - Manuel (Page 10)

10
A B
A. Standard rear offset exhaust installation
B. Left or right side exhaust installation
(27" wide models only)
C. Bottom exhaust installation (27" wide models only)
Alternate installations for close clearances
Venting systems come in many varieties. Select the type best
for your installation. Two close-clearance installations are shown.
Refer to the manufacturer’s instructions.
A B
A. Over-The-Top installation (also available with
one offset elbow)
B. Periscope installation
noTE: The following kits for close clearance alternate
installations are available for purchase. Please see the
“Assistance or Service” section of the “Dryer User Instructions.”
Over-the-Top Installation: ■
Part Number 4396028
Periscope Installation (For use with dryer vent to wall vent ■
mismatch):
Part Number 4396037 - 0" (0 mm) to 18" (460 mm) mismatch
Part Number 4396011 - 18" (460 mm) to 29" (737 mm)
mismatch
Part Number 4396014 - 29" (737 mm) to 50" (1270 mm)
mismatch
Special provisions for mobile home installations:
The exhaust vent must be securely fastened to a noncombustible
portion of the mobile home structure and must not terminate
beneath the mobile home. Terminate the exhaust vent outside.
C D
Determine vent path:
Select the route that will provide straightest and most direct ■
path outdoors.
Plan the installation to use the fewest number of elbows and
■
turns.
When using elbows or making turns, allow as much room
■
as possible.
Bend vent gradually to avoid kinking.
■
Avoid 90° turns when possible. ■
Determine vent length and elbows needed for best
drying performance:
Use following Vent system chart to determine type of vent ■
material and hood combinations acceptable to use.
noTE: Do not use vent runs longer than those specified
in Vent system chart. Exhaust systems longer than those
specified will:
Shorten life of dryer. ■
Reduce performance, resulting in longer drying times ■
and increased energy usage.
The Vent system chart provides venting requirements that will
help achieve best drying performance.
vent System Chart
number
90° turns or
elbows
Type of vent Box/louvered
hoods
Angled hoods
0 Rigid metal 64 ft. (20 m) 58 ft. (17.7 m)
1 Rigid metal 54 ft. (16.5 m) 48 ft. (14.6 m)
2 Rigid metal 44 ft. (13.4 m) 38 ft. (11.6 m)
3 Rigid metal 35 ft. (10.7 m) 29 ft. (8.8 m)
4 Rigid metal 27 ft. (8.2 m) 21 ft. (6.4 m)
noTE: Side and bottom exhaust installations for 27" wide
models have a 90º turn inside the dryer. To determine maximum
exhaust length, add one 90º turn to the chart.
vent System Chart (29" Wide long vent models only)
number
90° turns or
elbows
Type of vent Box, louvered,
or angled hoods
0 Rigid metal 120 ft. (36.6 m)
1 Rigid metal 110 ft. (33.5 m)
2 Rigid metal 100 ft. (30.5 m)
3 Rigid metal 90 ft. (27.4 m)
4 Rigid metal 80 ft. (24.4 m)
5 Rigid metal 70 ft. (21.3 m)