GE 7500 SERIES - Manuel (Page 16)

Installation Instructions
16
UTILITY CLOSET CONNECTION LOCATIONS
IMPORTANT:
Plan and locate plenum, wall plug, drains and
thermostat carefully to avoid interference. Hard-to-reach locations
will make installation and service difficult!
Reference Dimensions
A Thermostat cable: 9 1 ⁄
2
′ long
B Power cord: 60 ″ long
C Case width and depth: 23 1 ⁄
8
″
D Case height: 31
″
E Condensate drains: 3/4 ″ connector
• Primary Drain – Centerline of cutout is
approximately 5 1 ⁄
4
″ from left case wall
and 8 1 ⁄
2
″ from back case wall.
• Secondary Drain – Centerline of cutout is
approximately 6 1 ⁄
2
″ from left case wall
and 5 1 ⁄
4
″ from back case wall.
F Typical wall plug: 6 ″–12″ above case
G Room air sensor kit: 10
′ long
Outside wall
Flex duct may be used
for transitions only
Use rigid duct for 90°
bends and tees
F
C C
D
E
Platform
B A
230/208 VAC
wall receptacle
or
conduit for direct
connection
G