Harbor Freight Tools 93808 - Manuel (Page 14)

SKU 93808 For technical questions, please call 1-800-444-3353.
Page 14
English
INSPECTION, MAINTENANCE, AND CLEANING
WARNING! Always make sure the Trigger Switch (2) is in its “OFF” position,
and remove the Battery before performing any inspection, adjustments,
maintenance, or cleaning.
1. Keep the Circular saw clean; remove all sawdust that has accumulated.
2. Regularly inspect all mounting screws and knobs to ensure that they are properly
tightened.
3. Keep saw blades clean and sharp. Sharp blades minimize stalling and kickback.
4. Keep guards in good working order.
5. Keep motor air vent clean of dust and debris. Vacuum periodically.
6. If the tool is not operating normally, making unusual noises, appears defective or if
any other problem with the tool exists, stop using it immediately and get it repaired
by a qualified service technician.
7. Clean tool with a damp cloth and light detergent. Do not use solvents as they can
damage and crack the plastic parts.
8. If the tool does not start or operate at full power with a fully charged battery pack,
contacts on the battery pack may need to be cleaned.
9. Check for cracks or damage to the tool before using it.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS
MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES
ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALI-
FIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE
ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY
STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTI-
FIED AND LICENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK
AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACE-
MENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS
THERETO.