Harbor Freight Tools 93808 - Manuel (Page 13)

SKU 93808 For technical questions, please call 1-800-444-3353.
Page 13
English
PREPARE MATERIAL BEFORE CUTTING
1. Support large panels to minimize risk of blade pinching and saw kickback.
2. Use a rip fence or secured straight edge guide when ripping material.
3. Securely clamp material to be cut to work bench.
4. Make sure saw does not cut into supports or workbench.
5. Use the appropriate type of blade for the material you are cutting.
CUTTING
Warning: The user can be seriously injured if the tool is not used properly.
Read this entire manual before using. Verify that the Saw Blade is securely
tightened and both angle and height adjustment knobs are tight before
proceeding. See Page 17.
1. Mark the line you will be cutting.
2. Place the Base Plate (M) on material to be cut. Align the front notch of the Base
Plate (right edge aligns with saw blade) on the cut line. Make Sure the Saw Blade
is NOT touching the material you will be cutting at this point or the saw will
kickback!
3. To start the saw, depress the Trigger Release Button ( A) and squeeze the Trigger
Switch (B).
4. With the saw at full speed, move the saw slowly forward to complete the cut.
5. When the cut is complete, release the Trigger Switch (1) and the electric brake will
stop the blade instantly. Do not set the saw down until the blade stops turning.
6. Once the blade stops and work is complete, remove the battery and store the Circular
Saw in a safe location, out of reach of children.