Heath Zenith Carriage Light with Motion-activated 52-4474-4 - Manuel (Page 7)

7 598-1286-01
trOuBLeshOOting
If you experience a problem, follow this guide.
no service parts available for this product
syMptOM pOssiBLe cause sOLutiOn
Lights will not come
on.
1. Light switch is turned off.
2. Lamp is loose or burned out.
3. Fuse is blown or circuit breaker is turned off.
4. Daylight turn-off is in effect.
5. Incorrect circuit wiring, if this is a new instal-
lation.
1. Turn light switch on.
2. Check lamp and replace if burned out.
3. Replace fuse or turn circuit breaker on.
4. Recheck after dark.
5. Verify wiring is correct.
Lights come on in day-
light.
1. Light control may be installed in a relatively
dark location.
2. Light control is in TEST.
1. The fixture is operating normally under these condi-
tions.
2. Set control switch to 1, 5, or 10 minutes.
Lights come on for no
apparent reason.
1. Light control may be sensing small animals or
automobile traffic.
2. Sensitivity is set too high.
1. Reduce sensitivity.
2. Reduce sensitivity.
Lights stay on continu-
ously.
1. The sensor may be picking up a heat source
like an air vent, dryer vent, or brightly painted,
heat-reflective surface.
2. Light control is in Manual Mode.
3. Sensitivity is set too high.
1. Reduce sensitivity.
2. Switch to Auto.
3. Reduce sensitivity.
Lights flash on and off. 1. Light control is in the TEST mode and warm-
ing up.
2. Heat being reflected from other objects may
be affecting the sensor.
1. Flashing is normal under these conditions.
2. Reduce sensitivity.