Heath Zenith Carriage Light with Motion-activated 52-4474-4 - Manuel (Page 2)

2 598-1286-01
Wiring instaLLatiOn
For best performance, mount the fixture about 6 feet (1.8
m) above the ground.
1. Remove two decorative nuts.
2. Remove X-Bar.
3. Tighten mounting screws on X-Bar finger tight.
4. Attach X-Bar to junction box.
Junction Box
X-Bar
Decorative Nut
Lantern
Lantern Mounting
Screw
X-Bar
One Motion Light
Two Motion Lights
cautiOn: DO nOt connect the reD wire unless
you want to control other lights from the motion
sensor (see Optional Wiring).
Note: All wiring must be run in accordance with the
Canadian Electrical Code through conduit or another
acceptable means. Contact a qualified electrician if there
is any question as to the suitability of the system.
Warning: turn power off at circuit breaker
or fuse.
Bracket Mounting
Screw
Connect the fixture wires to the wires in the junction
box. Twist the wires together and secure with wire con-
nectors.
Note: We recommend having an assistant help hold the
lantern assembly during the wiring process.
Black
White
Green or
Bare
Black
White
Green or
Bare