Installation instructions, Requirements, Tools and parts – KITCHENAID 36 Inch Gas Cooktop Owner's Manual Manuel d'utilisation

Page 5: Installation instructions requirements, Tools needed, Parts supplied, For propane/natural gas conversions tools needed, Parts needed

Advertising
background image

5

Cleaning Method:

Soap and water:

Pull knobs straight away from control panel to remove.

Dishwasher Safe

CONTROL PANEL

To avoid damage to the control panel, do not use abrasive
cleaners, steel wool pads, gritty washcloths or abrasive paper
towels.

Cleaning Method:

Glass cleaner and soft cloth or sponge: Apply glass cleaner to
soft cloth or sponge, not directly on panel.

Affresh

®

Kitchen and Appliance Cleaner (not included): Order

Part Number W10355010

PORCELAIN-COATED GRATES AND CAPS

Food spills containing acids, such as vinegar and tomato, should
be cleaned as soon as the cooktop, grates and caps are cool.

These spills may affect the finish.

To avoid chipping, do not bang grates and caps against each
other or hard surfaces such as cast iron cookware.

Do not reassemble caps on burners while wet.

Cleaning Method:

Nonabrasive plastic scrubbing pad and mildly abrasive
cleanser:

Clean as soon as cooktop, grates and caps are cool.

Dishwasher (grates only, not caps):

Use the most aggressive cycle.

Gas Grate and Drip Pan Cleaner Part Number 31617 (not
included):

Refer to the Quick Start Guide for contact information.

SURFACE BURNERS

Sealed Burner models

See the “Sealed Surface Burners” section in the online Control
Guide.

SIMMER PLATE (on some models)

Do not clean in dishwasher.

Cleaning Method:

Liquid detergent and water:

Wipe with damp cloth or sponge then rinse with clean water
and wipe dry.

Mild-abrasive cleanser:

Rub in the direction of the grain lines with a damp cloth.

GRIDDLE (on some models)

To avoid damaging the nonstick surface, do not clean the griddle
with abrasive cleaners.

Cleaning Method:

Use soap and water or mild detergent.

INSTALLATION INSTRUCTIONS
REQUIREMENTS

Tools and Parts

Gather the required tools and parts before starting installation.

Tools Needed

Tape measure

Screwdriver

15/16" (24 mm) combination
wrench

Pipe wrench

Wrench or pliers

Marker or pencil

Pipe-joint compound
resistant to Propane gas

Noncorrosive leak-detection
solution

Parts Supplied

Gas pressure regulator

Burner grates

Burner caps

Clamping brackets (2)

2

1

/

2

" (6.4 cm) clamping screws (2)

For Propane/Natural Gas Conversions

Tools Needed

Flat-blade screwdriver

T20

®

TORX

®

screwdriver

Adjustable Wrench

7.0 mm nut driver

Masking tape

7.0 mm wrench

Parts Supplied

Propane orifice package

Conversion instructions

Conversion label

Parts needed

Check local codes and consult gas supplier. Check existing gas
supply and electrical supply. See “Electrical Requirements” and
“Gas Supply Requirements” sections.

NOTE:

Be sure to purchase only Whirlpool factory-certified parts

and accessories for your appliance. Your installation may require
additional parts. To order, refer to the contact information
referenced in your Quick Start Guide.

TORX

®

and T20

®

are registered trademarks of Acument Intellectual Properties, LLC.

Advertising
Ce manuel est liée aux produits suivants: